Dispensing hot water
!
Risk of burns
The milk frother 10 gets very hot. After use,
The appliance must be ready for use.
Place the pre-warmed cup or glass under
the outlet of the milk frother 10.
Select the required setting for hot water
Ê
by turning the knob 6.
Press the
start
button 8. Hot water runs
out of the milk frother outlet 10 for about
40 seconds.
Press the
start
button 8 again to cut the
process short.
N.B.: It is possible to set the temperature of
the hot water (see “Controls, °
C
button”).
Maintenance and daily
cleaning
!
Risk of electric shock
Unplug the appliance before cleaning it.
Never immerse the appliance in water.
Do not use a steam cleaner.
Wipe the outside of the appliance with a
soft, damp cloth. Do not use abrasive
cloths or cleaning agents.
Rinse the water tank 11 and the brewing
unit 23 with water only.
The cover of the storage compartment 25
and the drip tray panel 26 should only be
wiped gently with a damp cloth. Do not
put them in the dish washer.
Remove grate for coffee outlet 28 and the
grate for the milk frother 29. Take out the
drip tray for coffee outlet 27 with the
coffee grounds container 30 by pulling
them out forward, empty and clean. All
these parts can also be cleaned in the
dish washer.
Clean the measuring spoon 14, aroma
cover 16 and the milk container 32 by
hand or in the dish washer.
Wipe out or vacuum the inside of the
appliance (tray holders).
Important: Drip tray 27 should be emptied
and cleaned daily to prevent mould from
developing.
N.B.: If the appliance is cold when switched
on with the a button 2, or if it is set to a
mode after brewing coffee, it rinses
automatically, in other words the system
cleans itself.
Cleaning the milk system
Clean the milk system 10 immediately after
use!
The milk system 10 can be pre-cleaned
automatically.
Select the
Ì
symbol in the display 5 and
press the
start
button 8.
PLACE EMPTY GLASS UNDER FROTHER,
PLACE SUCTION PIPE IN GLASS
START
Place an empty glass under the milk
system 10 and put the end of the pipe
10d in the glass.
Press the
start
button 8. The appliance
-
ter and draws it in again through the pipe
10d for cleaning. The rinse procedure
stops automatically after about 1 minute.
Now empty the glass and clean the pipe
10d.
In addition to this, clean the milk system
thoroughly at regular intervals (by hand or
in the dishwasher).
Dismantling the milk system 10 for cleaning:
Pull the milk system 10 forward out of the
appliance.
Clean the individual parts (Fig. C) with a
detergent solution and a soft brush.
Rinse all parts with clear water and dry them.
Reassemble all the parts and replace fully
in the appliance.
Note: All the parts of the milk frother 10 can
also be put in the dishwasher.
