324045

Siemens ts 25 gp100 slider sl25 green power Seite 12

12
Zoom out
Zoom in
Vorherige Seite
1/102
Nächste Seite
12
Cleaning & Maintenance
Always unplug the appliance from the mains supply
before carrying out any cleaning or maintenance
operation on it.
1. After ironing, pull out the plug and allow the appliance to
cool down before cleaning.
2. Wipe the housing, handle and iron body with a damp
cloth.
3. If the soleplate is soiled with dirt or scale, clean it with a
damp cloth.
4. Never use abrasive products or solvents.
Storing the appliance (D)
1. Always allow the appliance to cool down before storing it.
2. Set the main power to the “0” position and disconnect the
mains cable.
3. Place the iron on the iron pad, standing on the soleplate.
4. Empty the water tank and store the mains cable on the
cord rewind facility. Tidy the steam hose on the handle of
the iron using the cord clip provided (14*). Do not wrap the
cords too tight.
* Depending on the model.
Fabric protection soleplate
cover (E)
(depending on the model)
The fabric-protection soleplate cover is used for steam-
ironing delicate garments at maximum temperature without
damaging them. Use of the soleplate cover also does away
with the need for a cloth to prevent shine on dark materials.
It is advisable to first iron a small section on the inside of the
garment to see if it is suitable.
To attach the soleplate cover to the iron, place the tip of the
iron into the end of the soleplate cover and pull the elastic
strap over the lower rear of the iron until it fits tightly. To
release the soleplate cover, pull the elastic strap and remove
the iron.
The fabric-protection soleplate cover may be purchased from
the customer service or specialist shops:
Accessory code
(After-sales)
Name of accessory
(Specialist outlets)
464847 TZ25100
464848* TZ25200*
571510** TZ20450**
* Cork handle iron
** Only for model TS25430
“Calc‘n clean” (F)
Cleaning the Boiler
To extend the life of your steam generator and to avoid any
build up of scale, it is essential that you rinse out the boiler
after several hours of use (approximately after 50 hours). If
the water is hard, increase the frequency.
Do not use descaling agents for rinsing out the boiler, as they
could damage it.
1. Check that the appliance is cold and unplugged for more
than 2 hours, and that the removable water tank (1) is
empty.
2. Place your appliance on the edge of your kitchen sink.
3. Remove the plastic cover located on the bottom of the
appliance by turning it to the
position.
4. Unscrew the boiler drainage plug located on the bottom of
the appliance using a coin.
5. Holding your steam generator in upside down position,
and using a jug, fill the boiler (in the base unit) with 1/4 litre
of water
6. Shake the base unit for a few moments and then empty it
completely over a sink or bucket. To obtain the best result,
we recommend that this operation is done twice
Important: before re-closing, make sure no water remains
in the boiler.
7. Replace and tighten up the boiler drainage plug with a
coin.
8. Insert and close the plastic cover by turning it to the
position.
Automatic clean warning
(depending on model)
Pilot light (3) will flash indicating that boiler must be rinsed. To
do this, follow the procedure described in the section above.
To reset “Calc‘n clean” pilot light and counter, switch the
station off twice, keeping it off during at least 30 seconds
each time
Rinsing the iron steam chamber (G)
This procedure helps to remove scale particles out of the
steam chamber.
Carry it out approximately every 2 weeks, if the water in your
area is very hard.
a) Ensure that the iron is cooled down.
b) Set the temperature selector (10) of the iron to the “min”
position.
c) Fill the tank with tap water.
d) Plug in the mains cable and set the main power switch (6)
to the “I” position.
e) Wait until the “steam ready” indicator lamp (7) lights up.
f) If the steam station has steam regulator (4), set it to the
maximum position (“10”).
g) Hold the iron over the sink or a container to collect the
water.
h) Press the steam release button (11) and gently shake
the iron. Boiling water and steam will come out, carrying
scale and or deposits that might be there. This could take
approximately 5 minutes.
i) Set the temperature selector (10) of the iron to the “max”
position, without pressing the steam release button (11).
The water in the steam chamber will start evaporating.
Wait until all the water inside the chamber has been
evaporated.
j) To clean the soleplate, immediately rub off any residue by
running the hot iron over dry cotton cloth.
en
… 12 …

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

siemens-ts-25-gp100-slider-sl25-green-power

Suche zurücksetzen

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Siemens ts 25 gp100 slider sl25 green power wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info