en Operating the appliance
22
detergent to compartment É È.
~ Page 26
Change the programme
default settings
You can use the default settings for
each washing cycle or change them.
To do this, repeatedly press the
corresponding button until the required
setting is displayed.
Note: Pressing and holding the buttons
automatically runs through the setting
values until the last one. Then press the
button again and you will be able to
change the setting values again.
The settings are activated without
needing to be confirmed.
Notes
■ The i-Dos settings are saved until
they are changed again, even if the
washing machine is switched off.
■ Other programme settings are not
saved if the washing machine is
switched off.
Default programme settings
~ Page 18
Select additional programme
settings
By selecting additional settings, you can
better adapt the washing process to
your items of laundry.
The settings can be selected or
deselected depending on the
programme progress.
The button indicator lamps light up if a
setting is activated.
The settings are not saved after
switching off the washing machine.
Additional programme settings
~ Page 20
Start the programme
Press the Ü button. The indicator lamp
lights up and the programme starts.
The display panel shows the "Ready in"
time while the programme is running or
the programme length and the
programme progress symbols when the
washing programme has started.
Display panel ~ Page 10
Note: Foam detection
If the o symbol also lights up in the
display panel, the washing machine has
detected too much foam during the
wash programme and automatically
activated additional rinse cycles to
remove the foam.
Add less detergent to the next washing
cycle with the same load.
If you want to lock the programme to
prevent it from being inadvertently
adjusted, you can select the childproof
lock as follows.
Child lock
(w 3 sec.)
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently. To do this,
activate the childproof lock.
To activate/deactivate, press and hold
the Finish in 0 - and + buttons at the
same time for approx. three seconds.
The w symbol is appears in the
display panel.
■ w lights up: The childproof lock is
active.
■ w flashes briefly: The childproof
lock is active and the programme
selector was turned or a button was
pressed.
Note: The childproof lock remains
active, even once the washing machine
has been switched off. Before selecting
