en Operating the appliance
40
Adding laundry
After starting the programme, you can
add or remove laundry if necessary.
Press the Ü button to do this.
The Ü button indicator lamp flashes
and the machine checks whether it is
possible to add laundry.
If the following appears in the display
panel:
■ Both the - P - and Ï symbols light
up, it is possible to add laundry.
■ - P - lights up, it is not possible to
add laundry.
To continue the programme, press the
Ü button. The programme continues
automatically.
Notes
■ Do not leave the door open for too
long when adding laundry as water
from the laundry may leak out.
■ For safety reasons, the door remains
locked when the water level or
temperature is high, while the drum
is turning or during the active oxygen
phase, and it is not possible to add
laundry during this time.
■ It is possible to add laundry during
the sensoFresh î programme.
■ The load display is not active during
reloading.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1. Press the Ü button.
2. Select another programme.
3. Press the Ü button. The new
programme starts from the
beginning.
Note: When switching from
programmes that use active oxygen to
those that do not, the door will remain
locked for up to 25 minutes until there
is no longer any active oxygen in the
drum.
The Ï and î symbols will flash. If the
symbols are off, the door can be
opened.
Cancel the programme
For programmes at high temperatures:
1. Press the Ü button.
2. To cool down laundry: Select Rinse .
3. Press the Ü button.
For programmes at low temperatures:
1. Press the Ü button.
2. Select Spin or Drain .
3. Press the Ü button.
Note: When cancelling programmes
that use active oxygen, the door will
remain locked for up to 25 minutes until
there is no longer any active oxygen in
the drum.
Switch the appliance on again if
necessary. The Ï and î symbols will
flash. If the symbols are off, the door
can be opened.
Programme end during rinse
hold
In the display panel, $ flashes, and the
preset spin speed and remaining
programme length are displayed for the
selected programme.
Continue the programme by:
■ Pressing the Ü button or
■ Changing the spin speed, or setting
the programme selector to Drain
and then pressing the Ü button.
