Bedienungsanleitung Siemens WM16W790 - iQ700 sensoFresh (Seite 49 von 56) (Englisch)

630102

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

Faults and what to do about them. en

Water remaining in the

care product

compartment i .

■ Not a fault – the effectiveness of the care product is not affected.

■ Clean the insert if necessary.

Odours in the washing

machine.

Run the Drum Clean î or Cottons 90 °C programme without laundry.

Add standard washing powder or a detergent that contains bleach.

Note: . To prevent foaming, only use half the amount of detergent

recommended by the detergent manufacturer. Do not use detergents intended

for woollens or delicates.

The o symbol is lit on the

display panel. Foam may

also be leaking from the

detergent drawer.

Have you used too much detergent?

Mix one tablespoon of fabric softener with 1/2 litre of water and pour it into

compartment II (not suitable for outdoor clothing, sportswear or items made

with down).

Use less detergent for the next wash cycle.

Loud noises, vibrations

and machine “wandering”

during the spin cycle.

■ Is the appliance level? Level the appliance. ~ Page 20

■ Are the appliance's feet secured? Secure the appliance's feet. ~ Page 20

■ Have the transportation securing means been removed? Remove the

transportation securing means. ~ Page 16

The display panel/

indicator lights do not

work while the appliance

is running.

■ Has there been a power failure?

■ Have the fuses blown/has the circuit breaker tripped? Switch on the circuit

breaker/replace the fuses.

■ If the fault occurs repeatedly, call the after-sales service.

There are noises after the

programme starts

sensoFresh î.

Not a fault – the appliance is filled with water to create mist; operating noises

from the fan and pump can be heard when it is doing this.

Water stains on dry

laundry after the

sensoFresh î

programme.

■ Was residual water removed before laundry was added?

■ Level the appliance. The active oxygen treatment can only work properly if

the appliance is levelled correctly. ~ Page 20

Noises can be heard after

the sensoFresh î

programme.

Active oxygen leaves a specific odour on the laundry following treatment. Shake

out the laundry briefly.

Odour has not been

removed satisfactorily

after the sensoFresh î

programme.

■ The active oxygen treatment is less effective if the drum is dirty. Run the

Drum Clean î programme before using the appliance for the first time,

and regularly thereafter.

■ Have you loaded too much laundry? Do not exceed the maximum load.

■ Have you selected a high enough intensity? Select a higher intensity.

~ Page 36

■ Leave the door and detergent drawer open so that any residual water can

evaporate. ~ Page 43

There is detergent

residue on the laundry.

■ Some phosphate-free detergents contain water-insoluble residue.

■ Select Rinse or brush the laundry after washing.

Faults Cause/remedy

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Siemens WM16W790 - iQ700 sensoFresh Seite 49

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Siemens WM16W790 - iQ700 sensoFresh

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info