Bedienungsanleitung Sigma sa 300 n (Seite 38 von 52) (Englisch)

295114

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

4. After you finish using the flash, close the flash head by pressing the

top part of the flash as shown in the illustration.

Excessive consecutive firing of the built-in flash may cause impairment

to the flash component. Do not fire the flash more than 36 times

continuously and, after a significant period of continuous firing, rest the

lash at east 10 minutes to allow the component to cool. Also, when you

use the flash continuously, the grip of the camera will become warm.

This is normal and not a defect.

When used with P mode

The camera will select the appropriate aperture value for any background. In bright situations, the camera will

calculate the appropriate flash amount to obtain correct exposure for both the subject and background. (Daylight

synchronization Flash)

If the subject is too bright or too dark, the aperture indicator will blink and will show limit values. If the subject is too

bright, use an ND filter to reduce the brightness. If the subject is too dark, the camera will proceed to take a flash

exposure with the aperture wide open.

When used with S mode

When you set the desired shutter speed, the camera will select the appropriate aperture value for the background. The

shutter speed will operate between 1/125 and 30 seconds. In bright situations, the camera will work the same as P

mode for Daylight synchronization Flash.

If the subject is too bright or too dark, the aperture value indicator will blink and will show limit values. If the subject

is too bright, use an ND filter to reduce the brightness. If the subject is too dark, the camera will proceed to take a

flash exposure with the aperture wide open.

If you adjust the shutter speed until the aperture value indicator stop blinking, you can get an appropriate exposure for

both the subject and background. (Slow Synchronization)

When used with A mode

When you set the desired aperture value, the camera will select the appropriate shutter speed for the background. The

shutter speed will operate between 1/125 and 30 seconds. In bright situations, the camera will work the same as P

mode for Daylight synchronization Flash.

If the subject is too bright or too dark, the shutter speed indicator will blink and will show limit values. If the subject

is too bright, use an ND filter to reduce the brightness. If the subject is too dark, set the aperture value to a wider one.

If you adjust the Aperture value until the shutter speed indicator stop blinking, you can get an appropriate exposure

for both the subject and background. (Slow Synchronization)

When used with M mode

You can set the desired shutter speed and aperture value. The shutter speed will operate between 1/125 and 30

seconds.

If you adjust exposure until the exposure meter indicates O (zero), the camera will work as for Daylight

synchronization Flash or Slow Synchronization.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sigma sa 300 n Seite 38

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info