10
Attaching the presser foot holder
Attaching the presser foot
Removing the presser foot
Attaching the seam guide
(1)
Raise the presser foot bar (a). Attach the presser
foot holder (b) as illustrated.
(2)
Lower the presser foot holder (b) until the cut-out
(c) is directly above the pin (d).
Raise the lever (e).
Lower the presser foot holder (b) and the presser
foot (f) will engage automatically.
(3)
Raise the presser foot.
Raise the lever (e) and the foot will disengages.
(4)
Attach the seam guide (g) in the slot as illustrated.
Adjust according to need for hems, pleats, etc.
Attention: Turn power switch to off ( ) when carrying out any of the above operations!"O"
Attention: Turn power switch to off. ( when carrying out any of the above operations!"O")
Change the needle regularly, especially if it is
showing signs of wear and causing problems.
Insert the needle following the illustrated
instructions.
A. Loosen the needle clamp screw and tighten
again after inserting the new needle.
The flat side of the shaft should be towards the
back.
B. Insert the needle as far up as it will go.
Needles must be in perfect condition.
Problems can occur with:
- Bent needles
- Blunt needles
- Damaged points
