Bedienungsanleitung Silvercrest IAN 338924 SKMC 1200 C3 (Seite 16 von 40) (Englisch)

750504

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

16 GB

CAUTION:

~The mixer attachment21 must only be used with

speed settings 1 to 4.

~The turbo button38 must not be pressed if the mixer

attachment21 is used.

~When using the mixer attachment21, the spatula22

must not be used, since it might get into the mixer at-

tachment21.

~When adding food, ensure that it will not block the

mixer attachment21.

In order to remove the mixer attachment21, pull it out up-

ward. If you feel resistance, turn it slightly.

10.5 Put on the lid of the blender jug

NOTE: the lid24 for the blender jug may only be put on

when the blender jug5 has been correctly inserted into the

base unit14. If you attach the lid first, the blender jug can

no longer be inserted into the base unit.

1. Place the lid24 for the blender jug so that the lock

symbols are opposite the arrows on the blender

jug5.

2. Press and turn the lid24 clockwise with both hands.

Only when the lid24 is correctly closed, can the de-

vice start. An audio signal indicates that the device is

ready for use.

NOTES:

• In order to facilitate the closing of the lid somewhat,

put a few drops of oil on a cloth and rub it on the

seal23.

• The device can only be started when the lid24 is put

on correctly.

10.6 Measuring beaker as lid for the

filling opening

Simultaneously, the measuring beaker25 is used to close

the lid of the blender jug5 and to measure ingredients

(20ml to 100ml).

• In order to close the blender jug5, place the measur-

ing beaker25 with the opening at the bottom into the

lid24 and lock it in place by turning it clockwise. It

clicks audibly.

CAUTION:

~Prior to removing the measuring beaker25, you must

reduce the speed to setting 1, 2 or 3, so that no food

can be ejected.

• In order to fill in ingredients, the measuring beaker25

can be removed briefly.

• To measure ingredients, turn the measuring beaker25

upside down and fill in the food. The values can be

read in ml.

10.7 Cooking and steaming with the

cooking pot

1. Fill at least 500 ml

of water into the blender jug

Only fill so much water into the blender jug

that the

maximum filling volume of 3 litres will not be exceeded

when the food is added.

- If the entire food is covered by water, it will be

cooked.

- If the food is not completely covered by water, it will

be steamed.

2. Fill food into the cooking pot20.

NOTE: always make sure that the filling level does not ex-

ceed the marking MAX.

3. Place the cooking pot20 into the blender jug5.

4. Close the blender jug5 with the lid24 and the

measuring beaker25.

5. Use the on/off switch7 to switch the device on.

6. Use the display dial29 to set the desired time.

7. Set the desired temperature on the display dial32,

e.g. 100 °C for cooking.

The touchscreen8 shows the time set and the selected tem-

perature.

8. Select the speed setting 1 for an even distribution of

the heat in the water.

9. Press the X35 button. The device starts to operate.

10. After the set time has elapsed, a signal sounds.

11. Press the on/off switch7 to switch the device off.

00:53 3 75 °C

__338924_1907_MC-Connect_GB_online.book Seite 16 Donnerstag, 12. Dezember 2019 10:09 10

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest IAN 338924 SKMC 1200 C3 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Silvercrest IAN 338924 SKMC 1200 C3

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info