766903
14
Zoom out
Zoom in
Vorherige Seite
1/61
Nächste Seite
12 GB
7. Place the mixing tool4/6/7 onto the
axle13 from below.
Ensure that the metal pin on the axle13
slots into the recess in the mixing tool.
8. Figure A: press the mixing tool4/6/7
upwards slightly and rotate it anticlock-
wise until it stops.
Adding ingredients
You can add ingredients into the mixing
bowl5 while the drive arm12 is lifted
up.
During mixing, you can add ingredients
through the filling opening10 in the
splash guard11:
- Reduce the speed to 1 - 2.
- Add the ingredients.
DANGER of hand injuries by
crushing!
~Never put your hands between the drive
arm12 and the housing. There is a risk
of injury from crushing when folding
down.
9. Press the unlock button1 and move the
drive arm12 all the way down. The un-
lock button1 pops out again.
Basic operation
Power supply
DANGER! Risk of electric
shock!
~Only connect the mains plug3 to a
properly installed and easily accessible
wall socket whose voltage corresponds
to the specifications on the rating plate.
The wall socket must still be easily ac-
cessible after the device is plugged in.
NOTE: when the device is used the first few
times, some odour may be generated by the
device due to the heating of the motor. This
is harmless. Please ensure adequate ventila-
tion.
1. Assemble the device for the desired
function.
2. Check that the speed control2 is set to
0 (off).
3. Plug the mains plug3 into a suitable
wall socket. The wall socket must still be
easily accessible after connection.
4. Pull out the mains plug3 before clean-
ing the device.
Switching the device on/off and
selecting speed
WARNING! Risk of material damage!
~The mixing mechanism must not be op-
erated continuously for longer than
10 minutes at a time. You must then al-
low the device to cool down to room
temperature.
NOTE: the device may move slightly while
you are processing large quantities of
dough.
1. Switch the device on by turning the
speed control2 clockwise.
2. Start at a slightly lower speed, and
slowly increase to the desired speed.
__360495_2010_KURZ_B8.book Seite 12 Dienstag, 2. Februar 2021 3:20 15
14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Silvercrest IAN 360495 SKM 600 B2 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info