Bedienungsanleitung Silvercrest IAN 54385 (Seite 28 von 40) (Englisch, Portugiesisch, Spanisch)

738648

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

32 GB/MT

Preparing for use

Safety advice / Preparing for use

J Exhausted or damaged batteries

can cause caustic burns upon con-

tact with the skin. To avoid this,

always wear suitable protective gloves in these

circumstances!

J Make sure you insert the batteries the right

way round (polarity). The “+” symbol must be

visible on the top of the battery.

J Batteries do not belong in the household refuse

bin!

J Every consumer is obliged to dispose of batter-

ies properly in accordance with the regulations.

J Keep batteries away from children. Do not

throw batteries into a ﬁre. Never short-circuit

them or take them apart.

J Avoid contact with the skin, eyes and mucous

membranes if ﬂuid is leaking from a battery. If

you come into contact with corrosive battery

ﬂuids, ﬂush the aﬀected area thoroughly with

clean water and contact a doctor immediately.

J Remove the batteries from the device if they

have not been used for a long period.

J Remove exhausted batteries from the device

immediately, otherwise the batteries are likely

to leak.

J If you disregard these instructions and advice,

the batteries may discharge beyond their mini-

mum voltage, thus increasing the chance of

leakage. If your batteries leak, remove them

from the device immediately to prevent it from

being damaged!

Preparation for use

Removing the insulation strips

from the batteries

j Slide open the battery compartment cover

and take it oﬀ the battery compartment

j Remove the battery insulation strips.

j Close the battery compartment

with the

battery compartment cover

j If the scales do not appear to work, check that

the batteries have been inserted correctly and

reinsert them if necessary.

j When you are inserting the batteries, make

sure that you do not permanently bend the

contacts.

j Follow the instructions for inserting the batteries

as described in the section on “Replacing the

batteries”.

Setting the unit of weight

Note: The default unit of weight is the kilogram (kg).

The factory default setting for the scale as supplied

is “kg”.

j Slide the switch

(kg/lb/st) to the desired

unit of weight.

Setting the time

The value appears in the LC display

after

the insulation strips have been removed from the

batteries. The hour value ﬂashes.

Note: The time is shown in 24-hour format.

Note: If you do not press a button within 30 sec-

onds, the time appears automatically as

j Press the

-button

or the -button

to set

the hour value.

j Conﬁrm your settings by pressing the SET

button

. The minute value ﬂashes.

j Press the

-button

or the -button

to set

the minute value.

j Conﬁrm your settings by pressing the SET

button

Switching the time

display on/oﬀ

The time display can be switched oﬀ to increase

battery life.

j Press the SET button

for about 5 seconds.

The hour display goes out.

j Press the SET button

for about 5 seconds

again. The value

appears in the LC

display

54385_silv_Digitale_Personenwaage_Content_LB5.indd 32 08.03.11 11:18

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest IAN 54385 Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Silvercrest IAN 54385

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info