Bedienungsanleitung Silvercrest IAN 71779 (Seite 8 von 52) (Englisch)

575349

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

10 GB/CY

Operation

j Press the Digital timer / UNIT / Alarm / -

button

to start the alarm function. The

Alarm symbol

appears in the display.

j You can switch oﬀ the alarm function by

pressing the Digital timer / UNIT / Alarm / -

button

again. The Alarm symbol

disappears from the display.

j When the set alarm time is reached, an

audible alarm signal sounds for about one

minute.

j No audible alarm signal sounds if the set

time is reached when the device is in the

weighing mode. Instead the Alarm symbol

ﬂashes in the display.

Note: If no button is pressed within a period

of two minutes, the kitchen scale’s display

automatically shows the time.

Using the digital timer

j Press the MODE / + button

until the

device enters the digital timer mode. This

comes after the alarm function.

j Press the SET / WEIGHT MODE button

to enter the settings mode. The seconds

display value ﬂashes.

j You can use the MODE / + button

or the

Digital timer / UNIT / Alarm / - button

set the value.

j Press the SET / WEIGHT MODE button

to store the set value and move on to setting

the minute display value. The minute display

value ﬂashes.

j You can use the MODE / + button

or the

Digital timer / UNIT / Alarm / - button

set the value.

j Press the SET / WEIGHT MODE button

to store the set value and leave the settings

mode.

j Press the Digital timer / UNIT / Alarm /

- button

to start the digital timer. The digital

timer indicator

appears in the display.

Note: While the digital timer continues to

run, you can switch the device to another

function by pressing the MODE / + button

The digital timer indicator

then continues

to appear in the display.

j You can switch oﬀ the digital timer by press-

ing the Digital timer / UNIT / Alarm /

- button

again. The digital timer indicator

disappears from the display.

j When the set time expires, an audible alarm

signal sounds for about one minute and the

previously set time appears on the display.

j No audible alarm signal sounds if the set

time is reached when the device is in the

weighing mode. Instead the digital timer

indicator

ﬂashes in the display.

Note: If no button is pressed within a period

of two minutes, the kitchen scale’s display

automatically shows the time.

Resetting the settings

j The reset button

can be found on the

back of the housing. Press this button to reset

all the settings to the default factory settings.

Replacing the batteries

j When the batteries become weaker, the

battery charge state indicator

in the

display will light up.

j Replace the batteries as soon as the symbol

“

” appears in the display. Weak or ex-

hausted batteries can aﬀect the accuracy of

the measurement results.

j Open the battery compartment

on the

back of the scale.

j Remove the discharged batteries and dispose

of them properly in accordance with the ap-

plicable regulations (see section “Disposal”).

j Insert two new batteries type CR2032,

3 V

into the battery compartment

Make sure you ﬁt the batteries the right way

round (polarity). The correct polarity is

shown under the battery compartment

j Then close the battery compartment

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest IAN 71779 Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Silvercrest IAN 71779

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info