Bedienungsanleitung Silvercrest KH 1270 (Seite 24 von 34) (Englisch, Italienisch, Spanisch)

470707

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

- 22 -

Curtain and soft furnishing care

• Creases and wrinkles can be removed from

draperies by hanging them over a pole.

• Then simply follow the directions given under

“Clothing care”.

• Always carry out a test first at a concealed part.

• If you are using the appliance horizontally, every

now and then hold it upright so as to have the

maximum steam performance.

Fluff brush

• Threads, fluff and hairs can be easily removed

with the red fluff brush e by slowly brushing

over the garment with it from left to right.

• You can clean the fluff brush e by brushing with

it in the opposite direction (from right to left)

over, for example, a remnant of material.

Ironing function

• Dismantle the brush attachment w from the

appliance (see “Attaching/detaching the brush

attachment”).

• Connect the appliance to a correctly installed

and earthed mains power socket.

• Adjust the temperature regulator 3 as per the

international point symbols (Care Label) or the

type of material. The heating-up control lamp 5

glows. As soon as the set temperature has been re-

ached, the heating-up control lamp 5 goes out .

Washing label Type of material Temperature

regulator 3

Chemical fibres,

e.g. viscose,

polyester

•

(low

temperature)

Silk, Wool

••

(medium

temperature)

Cotton, Linen

•••

(high

temperature)

Note:

If doubt exists, start with a low temperature and

gradually increase it to a higher one. With sensitive

materials we recommend carrying out an ironing

test at a concealed part (inside seam).

• Should the heating-up control lamp 5 glow during

the process, release the steam blast button 8

and wait for a few moments until the heating-up

control lamp 5 extinguishes.

• You can repeatedly press the steam blast button

8 until the heating-up control lamp 5 glows or

water drips from the sole of the iron 0. Then,

wait until the heating-up control lamp 5 extin-

guishes before activating a further blast of

steam.

Note:

Should you press the steam blast button 8 whilst

the heating-up control lamp 5 is glowing the result

will be condensed water instead of steam, and water

will drip from the sole of the iron 0.

Should the water tank 1 become empty while the

appliance is in use, remove the plug 7 from the

power socket before refilling it.

• If you want to put the appliance down during

use, fold out the stands 9 to the front and place

the appliance on them. When you are ready to reu-

se the appliance, simply fold the stands 9 back

to the rear.

After using the steam brush

• Place the temperature regulator 3 at the position

"MIN".

• After use, ALWAYS remove the plug 7 from the

power socket.

• Pour away any water remaining in the water

tank 1 to do this, open, the water fill opening

2 of the water tank 1, turn the appliance upsi-

de down and lightly swivel it.

IB_KH1270_E40979_LB5 17.10.2008 11:25 Uhr Seite 22

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest KH 1270 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Silvercrest KH 1270

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info