118074
8
Zoom out
Zoom in
Vorherige Seite
1/16
Nächste Seite
10 GB
- Position loudspeakers as such on the shelf
that the front edge stands flush with the
edge of the shelf.
- To avoid booming, place a rubber mat under
the loudspeakers.
5. Use the cinch connections AUX IN
H
to con-
nect an external unit (e.g. turntable
1
).
6. For FM radio reception connect a 75 Ohm
antenna (house antenna, cable connection;
only possible for the following models: Ger-
many, Netherlands, Austria, Finland, Sweden,
Norway) to the antenna connection ANT
K
. If
this is not available then attach the supplied
longwire antenna to the centre contact of the
antenna connection. The antenna for AM con-
nection is already built into the unit.
7. Connect the plug into a 230 V outlet.
8. Insert suitable batteries (not included in the
delivery) into the remote control (2x AAA LR03
1.5 V):
- Open the cover to the rear of the remote
control.
- Insert the batteries. Observe the correct
polarity (see indication to the bottom of the
battery compartment).
- Close the cover again.
1
Only turntables without magnetic systems
are suitable for connection to this Designer
Audio Unit!
˿ Wall-mounting
The designer system and speakers can be
wall-mounted. The required screws and wall-
mountings are included in the delivery. Attach the
system vertically to a stable wall.
The holes for the screws must be drilled vertically
at a distance of 14 cm.
For the screws to grip correctly into the mount-
ings
L
to the rear of the designer system and
the loudspeakers the heads of the screws must
protrude approx. 3 mm from the wall.
˿ Switching on and off
[ » POWER/STAND-BY « ]
· When connecting the plug the system goes
into stand-by mode. Set the time while in
stand-by mode (see „Setting the clock“,
page 11).
· Activate POWER
F
to switch between operat-
ing mode and stand-by mode.
· During longer periods of absence disconnect
the plug.
˿ Select system/sound source
[ » CD/TUNER/TAPE/AUX « ]
· Activate one of the following buttons to select
an audio unit or to change the sound source:
CD/MP3
R
a: CD player/MP3 player
TUNER/BAND
R
b: Radio
TAPE
R
c: Cassette player
AUX
R
d: External unit, e.g. turntable
1
1
Only turntables without magnetic systems
are suitable for connection to this Designer
Audio Unit!
˿ Set volume
[ » VOLUME/MUTE « ]
· Press VOL/UP
A
to increase the volume.
· Press VOL/DN
p
to decrease the volume.
· Press MUTE
[
to mute the loudspeakers and
the headphones. Press again to deactivate
this function.
Operation: General
o this
2315_UK_Inhalt.indd 102315_UK_Inhalt.indd 10 29.10.2004 11:37:27 Uhr29.10.2004 11:37:27 Uhr
8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Silvercrest KH2315 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info