Bedienungsanleitung Silvercrest SDB 1500 A1 - IAN 114903 (Seite 9 von 57) (Deutsch, Englisch, Holländisch, Schwedisch, Finnisch)

754156

Zoom out

Zoom in

Vorherige Seite

1/57

Nächste Seite

9 GB/IE

Before Initial Use / Start-up

Before Initial Use

Attaching the steam broom

Remove the device from the packaging.

Attach the motor body 2 to the steam base 9

(Fig. A).

Tighten both parts together using the retaining

screw 21 and a Phillips screwdriver (Fig. B).

ATTENTION! Check the seating of the retain-

ing screw 21 regularly. Otherwise the steam

base 9 may detach itself from the device.

Press the handle release button 1. Lift up the

handle 15 until it clicks into place on the motor

body 2 (refer to Fig. C and Fig. D).

Preparing the steam broom

Unroll the mains cable 4 completely. You can

lower the pivotable cable winder 14 to make

this easier.

Pull the release lever of the water tank 12

upward in the direction shown by the arrow

(Fig. E) and remove the water tank 11 .

Turn the water tank 11 over and remove the

seal (Fig. F).

Fill the water tank 11 to the lower edge of the

thread with cold tap water (Fig. G). Screw the

seal back on without using too much force.

ATTENTION! In cases of particularly hard

water (with a water hardness of more than

2 mmol / l), use a mixture of 50 % tap water

and 50 % distilled water.

Re-insert the water tank 11 into the device and

ensure that the water tank valve is correctly

seated on the ﬁlter inlet (Fig H). Then click the

water tank 11 into the appropriate position

and check for the correct seating.

Start-up

Note: You can only use the turbo broom 18 , the

steam function or both functions at the same time.

However, we recommend that you use the two

functions after one another and ﬁrst use the turbo

broom 18 to remove dust from the ﬂoor. Only

activate the steam function thereafter.

Note: There is a groove below the handle into

which you can clamp the mains cable so that it

does not hang in the way during operation.

Switching the turbo

brush on/oﬀ

Press the ON/OFF switch 5 to switch on the

turbo brush 18 (Fig. I). The turbo brush 18 be-

gins to rotate and removes dirt and dust from

the ﬂoor, and collects it in the dust collector 6.

ATTENTION! Do not clean the turbo brush 18

during this process. The steam base 9 could

tip over or the dust collector 6 could fall

down. Risk of injury!

Press the ON/OFF button 5 again to switch

oﬀ the turbo brush 18 .

Using the steam function

Only use the device in well-ventilated rooms.

Remove the plug from the socket.

Use the blue pad 8b for soft ﬂoors and the

white pad 8a for hard ﬂoors. Place the pad 8

under the steam base 9 onto the relevant felt

attachment 19 (Fig. J).

ATTENTION! Ensure that the water tank is full

to prevent operation without water - otherwise

the pump could burn through.

ATTENTION! Similarly check before use that

all objects and surfaces to be cleaned are heat

resistant and/or compatible. We recommend

that you follow the care instructions of the man-

ufacturer, particularly for treated terracotta and

wooden ﬂoors. Conduct a test on an area which

is not easily visible or on a sample piece.

ATTENTION! There is a risk that a white

edge may develop on the ﬂoor if the device is

allowed to rest in the same spot for an ex-

tended duration during operation. This edge is

not indicative of damage! You can remove it

114903_silv_Dampfbesen SDB 1500 A1_content_FI_NL.indd 9 11.06.15 17:08

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest SDB 1500 A1 - IAN 114903 Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info