Bedienungsanleitung Silvercrest SDRB 1000 A1 - IAN 93147 (Seite 11 von 81) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Schwedisch, Finnisch)

576765

Zoom out

Zoom in

Vorherige Seite

1/81

Nächste Seite

- 8 -

Note:

For the steam blast function, set the temperature

regulator 3 to at least •••. At lower settings the

temperature is not sufficient to generate a steam blast.

• By pressing the steam blast button 8 you can

now produce jets of steam.

Note:

To release the first steam blast after heating the appli-

ance up, it can happen that you may need to press

the steam blast button 8 several times in succession.

The appliance is now ready for use.

Attention!

The steam brush can be used with all clothing items.

Caution is to be exercised with heat-sensitive materials

such as synthetics, polyamides or artificial silk. With

these materials you should first check at a concealed

part (inside seam) that the hot steam will not cause

any damage to the garment. Do not touch these ma-

terials directly with the hot sole of the iron 0. Use

only the steam blast.

Clothing care

• Suspend the crumpled garment from a coat hanger.

• With one hand pull the garment flat, then steam it

from top to bottom. The combination of steam and

clothes brush r will gently remove all creases.

• Use light pressure with the clothes brush r and

guide the appliance from top to bottom over the

garment. You can thereby press the steam blast

button 8 in short intervals.

Note:

You can repeatedly press the steam blast button 8

until the heating-up control lamp 5 glows or water

drips from the sole of the iron 0.

Then, wait until the heating-up control lamp 5 extin-

guishes before activating a further blast of steam.

• If the heating-up control lamp 5 lights up during

operation, do not press the steam blast button 8.

Wait a few seconds until the heating-up control

lamp 5 goes out before pressing the steam

blast button 8 again.

Note:

Should you press the steam blast button 8 whilst

the heating-up control lamp 5 is glowing the result

will be condensed water instead of steam, and water

will drip from the sole of the iron 0.

• Leave the garment on the clothes hanger to cool

down before putting it on.

Curtain and soft furnishing care

• Creases and wrinkles can be removed from

draperies by hanging them over a pole.

• Then simply follow the directions given under

“Clothing care”.

• Always carry out a test first at a concealed part.

• If you are using the appliance horizontally, every

now and then hold it upright so as to have the

maximum steam performance.

Fluff brush

• Threads, fluff and hairs can be easily removed

with the red fluff brush e by slowly brushing

over the garment with it from left to right.

• You can clean the fluff brush e by brushing with

it in the opposite direction (from right to left)

over, for example, a remnant of material.

IB_93147_SDRB1000A1_FI_SE_DK_BE.qxp 07.08.2013 11:12 Uhr Seite 8

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest SDRB 1000 A1 - IAN 93147 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info