Bedienungsanleitung Silvercrest SDWH 180 A1 - IAN 285970 (Seite 22 von 52) (Deutsch, Englisch, Holländisch)

668039

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

23 GB/IE

Initial use / Use

Adjusting the time

The value (0:00) appears on the LC display

af-

ter the insulation strip has been removed from the

batteries.

If you would like to adjust the time during normal

operation, press the SET button

for 3 seconds.

The hour display will ﬂash.

Press the button

or the button

adjust the hour.

Press the SET button

to conﬁrm your entry.

The minute display will ﬂash.

Press the button

or the button

adjust the minutes.

Press the SET button

to conﬁrm your entry.

Adjusting the unit of weight

Note: The factory default setting for the scales as

supplied is “kg”. If you would like to change to „lb“

or „st“ proceed as follows:

Press the SET button

until you reach the

„0.0 kg“ display.

Then, press the SET button

for 3 seconds.

The kg unit will begin to ﬂash.

By pressing the button

within 2 seconds,

you can select the desired unit of weight.

Note: If you select the „lb/st“ unit of weight, the

height will be displayed in „feet/inches.“ If you

select the „kg“ unit of weight, the height will be

displayed in „cm“.

Use

Switching on your

scales / measuring your weight

Tip: Weigh yourself at the same time of day (pref-

erably in the morning) after visiting the toilet, with

an empty stomach and without clothing to ensure

that your results are comparable.

Place the scales down on a solid, ﬂat, horizon-

tal surface.

Note: Do not place the scales on a carpet, as

this may inﬂuence the results. If necessary you

can place a board on the carpet and place the

scales upon this. A solid ﬂoor covering is required

in order to achieve correct weight measure-

ments.

You can attach the hand-held unit

to the

scales (see Fig. A) or have the option of

holding it in your hand (see Fig. B).

Optionally: You can also hang the hand-

held unit

on a nail or screw using the slot

on the reverse side and therefore hang it to

the wall.

Important! The scales work via infrared

transmission. You must therefore ensure that

there is a direct connection between the infra-

red transmitter

on the scales and the infra-

red receiver

on the hand-held unit

There should be no obstacles between the

scales and the hand-held unit

. The infrared

transmitter

and the infrared receiver

should also not be covered.

Note: There is a limited range between the in-

frared transmitter

and the infrared receiver

(max. 1.80 m vertically).

Distribute weight evenly on both legs when you

step onto the scales. The hour display disap-

pears.

If at all possible, stand on the same areas of

the platform each time and do not move. Mov-

ing during the weighing process can lead to

discrepancies in the results. The scales will start

to measure immediately. The measurement

result will be displayed on the LC display

When the displayed weight ﬂashes thrice, the

measurement is complete.

Note: The scales are overloaded if the dis-

play shows “Err”. Do not exceed the maximum

load capacity of 180 kg (396 lb / 28 st).

Step oﬀ the platform. The LC display

will

show the time once more.

Note: Do not use the scales in the vicinity of

electromagnetic ﬁelds. This could aﬀect the

measurement results.

Safety instructions / Initial use

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest SDWH 180 A1 - IAN 285970 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info