Bedienungsanleitung Silvercrest SEF 2300 B2 - IAN 270289 (Seite 63 von 74) (Deutsch, Englisch, Holländisch, Französisch)

646952

Zoom out

Zoom in

Vorherige Seite

1/74

Nächste Seite

~ The lid should be kept closed during

heating and frying.

~ During frying, hot steam escapes from

the grease filter. Be careful not to put

your hands into the steam.

~ Do not touch any hot parts of the device

such as the inspection window. The fry-

ing basket should only be touched at

the handle.

~ After frying, the fryer should cool down

for at least 1 to 2 hours before you emp-

ty the oil container and clean the de-

vice.

DANGER of slipping

~ Avoid any splashes of oil/fat on the

floor. There is a danger of slipping!

DANGER! Risk of electric

shock due to moisture

~ Protect the heating unit from moisture,

dripping and water splashes.

~ Do not use the device in the open air or

near vessels filled with water, e.g. sinks.

~ If the heating unit has fallen into water,

remove the mains plug immediately,

and only then remove the device from

the water. Do not use the device again,

and have it checked by a specialist

workshop.

~ Never touch the heating unit with wet

hands.

DANGER! Risk of electric

shock

~ Do not use the device if the device or

the power cable has any visible dam-

age, or if the device has previously

been dropped.

~ Extension cables must be designed for a

minimum of 10 ampere.

~ Lay the power cable and any extension

cable such that nobody can step on

them, get caught on them, or trip over

them.

~ Before connecting the device, check that

the temperature controller is set to the

"MIN" marking.

~ Connect the mains plug only to a cor-

rectly installed, easily accessible

earthed wall socket with voltage corre-

sponding to the rating plate. The wall

socket must continue to be easily acces-

sible after the device is plugged in.

~ Ensure that the power cable cannot be

damaged by sharp edges or hot points.

Do not wrap the power cable around

the device.

~ Even after it has been switched off, the

device has not been completely discon-

nected from the mains. In order to fully

disconnect it, pull out the mains plug.

~ When setting up the device, make sure

that the power cable is not trapped or

crushed.

~ To pull the mains plug out of the wall

socket, always pull on the mains plug,

and never on the power cable.

~ Disconnect the mains plug from the wall

socket …

… if there is a fault,

… if the device or the power cable is

damaged;

… when you are not using the device;

… before you clean the device and

… during thunderstorms.

~ Do not connect another device with a

high power consumption to a wall sock-

et on the same circuit. This way you will

avoid overloading the mains power sup-

ply.

~ Do not connect the device by using a

multiple socket. By doing so the socket

might be overloaded.

~ To avoid any risk, do not make modifi-

cations to the device.

B53B)ULWWHXVHB%ERRN6HLWH0LWWZRFK$XJXVW

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest SEF 2300 B2 - IAN 270289 Seite 63

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info