Bedienungsanleitung Silvercrest SFR 1200 A1 IAN 74435 (Seite 28 von 35) (Deutsch, Englisch, Holländisch)

739556

Zoom out

Zoom in

Vorherige Seite

1/35

Nächste Seite

28 GB

Safety / Before first use

In order to ensure that

your shaver works

perfectly, please observe

the following

Never expose your shaver to temperatures below

0 °C or above +40 °C. Do not place the shaver

down on radiators or fan heaters.

Always make sure that the ﬂex does not get

jammed in cupboard doors or is pulled over

hot surfaces.

Do not use a screwdriver or pliers to change

the cutter set

. This will damage the shaving

foil

Please use only the original AC adaptor plug

supplied with your shaver for mains operation.

Insert the plug only into a socket within easy

reach. In order to avoid inadmissible overheating,

do not cover the AC adaptor plug.

Please check the AC adaptor plug and shaver

for any mechanical faults at regular intervals.

Replace faulty parts with an original part if

possible (see your specialist dealer). Never try

to repair a faulty appliance yourself! Repairs

should only be carried out by a specialist

dealer or by our service centre (see section

“Warranty and service”).

Used or defective rechargeable bat-

teries must not be disposed of with

the usual domestic waste! Always

take your used rechargeable batteries to the

designated collection point (see section on

“Disposal”).

Before ﬁrst use

CAUTION! Oil residue on the shaving foil.

Due to the manufacturing process, you may ﬁnd

some oil residue still on the shaving foil when

you unpack the razor. Remove the oil with an

absorbent, lint-free cloth before starting the

device for the ﬁrst time.

The shaver can be used as a battery-operated or

mains-operated device.

Operating the shaver using the

AC adaptor plug

CAUTION! RISK OF ELECTRIC SHOCK!

Never touch the device with wet hands when it

is connected to the mains supply.

First insert the connection lead of the plug-in

mains adapter into the input socket for the

plug-in mains adapter

on the underside of

the device and insert the plug-in mains adapter

into the mains socket. The device is ready for

immediate use.

Charging the rechargeable

batteries

The shaver has two high-capacity Ni-MH recharge-

able batteries with overcharge protection. The

batteries can be recharged without undergoing

a reduction in performance. There is no risk of over-

charging them.

Note: Allowing the rechargeable batteries to be

completely discharged before recharging them will

increase their overall service life. To completely

discharge the batteries, run the device until the

charge reduces to 20 % and the LED starts to ﬂash

red (indicating that a recharge is necessary).

The rechargeable battery in the shaver should be

charged for at least 120 minutes before the shaver

is used for the ﬁrst time. For subsequent recharging

processes, a charging time of about 90 minutes is

adequate. Proceed as follows to charge the batteries:

Switch oﬀ the device. Slide the ON / OFF

switch

downwards.

Connect the connection lead of the plug-in mains

adapter to the input socket for the plug-in mains

adapter

on the shaver. The device begins

the charging process.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest SFR 1200 A1 IAN 74435 Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Silvercrest SFR 1200 A1 IAN 74435

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info