740037
51
Zoom out
Zoom in
Vorherige Seite
1/58
Nächste Seite
49
GB
4. Items supplied
1 Men's shaver
1 Protective lid11
1 Plug-in power unit with corresponding ca-
ble14
1 Cleaning brush15
1 Storage pouch16
1 Set of operating instructions
5. Charging
NOTES:
Charge the batteries for at least 2 hours
before using the device for the first time.
After that, a charging time of 90min-
utes is sufficient.
In order to increase the service life of
the batteries, we recommend …
to use the device regularly and with-
out long storage times,
… to discharge the batteries prior to the
charging procedure (LED 208 flash-
es red).
The LEDs of the battery capacity/charg-
ing indicator8 show the capacity/
charging status of the batteries in per-
cent (20, 40, ..., 100 FULL).
If the batteries are almost discharged,
the LED 20 of the battery capacity indi-
cator flashes red. The device can then
only be used for a short time without be-
ing connected to the electricity supply.
It takes about 5 minutes to charge the
device sufficiently for one shave.
When the batteries are fully charged,
the device can be used for approximate-
ly 90 minutes without being connected
to the power supply.
1. Switch off the device with the on/off
switch6 if necessary.
2. Connect the plug-in power unit14 to
the socket9 on the device.
3. Insert the plug-in power unit14 in into
an easily accessible wall socket, the
voltage of which corresponds to the rat-
ing plate.
4. The LEDs of the charging indicator8
flashes green, which indicates that the
batteries are being loaded. When the
batteries are fully charged, the LEDs of
the charging indicator light up green.
6. Operation
6.1 Before switching on for
the first time
CAUTION: after unpacking, there could
still be oil residues on the shaving foils. Re-
move these with an absorbent, lint-free cloth
before using the device for the first time.
6.2 Switching on and off
Irrespective of the batteries’ charging status,
the device can be used at any time in mains
operation.
1. In order to use the power pack, ensure
that the device is switched off.
2. Connect the plug-in power unit14 to
the socket9 on the device.
3. Insert the plug-in power unit14 in into
an easily accessible wall socket, the
voltage of which corresponds to the rat-
ing plate.
4. Remove the protective lid11 before
switching on.
5. To switch on, press the release button7
and push the on/off switch6 upwards.
6. To switch off, push the on/off switch6
downwards.
__GRA90253_B2.book Seite 49 Mittwoch, 24. April 2013 9:38 09
51

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Silvercrest SFR 1200 A1 IAN 90253 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info