Bedienungsanleitung Silvercrest SGP 230 A1 IAN 71528 (Seite 5 von 46) (Englisch, Italienisch, Portugiesisch, Spanisch)

739513

Zoom out

Zoom in

Vorherige Seite

1/46

Nächste Seite

3 • Using your steam generator

Press on the on / off switch (fig.4), it is flashing.

When starting, and regularly while it is being

used, your steam generator's electric pump

injects water into the boiler. It makes a noise

but this is quite normal.The generator and the

iron are ready to iron when the steam ready

indicator light is lit and the iron thermostat

dial light has gone out.

4 • Operating the control panel

• Flashing green light: the water is heating up

in the boiler (fig.7)

• Continuous green light: steam is ready for

use (fig.7)

• Continuous red light: the water tank is empty

(fig.11).

• Orange light flashes: your boiler needs

rinsing (fig.13).

DESCRIPTION

1. Humid steam button

(depending on model)

2. Iron handle

3. Steam control button

4. Temperature control dial for iron

soleplate

5. Iron rest

6. Removable water tank filler cover

7. Water tank

8. Iron temperature control light

9. Boiler rinse cap cover / Boiler rinse cap

10. Rinsing accessory

11. Steam power cord

12. Steam cord storage clip

13. Control panel

a. Illuminated on / off switch

b. “Steam ready” light

c. Steam output control dial

d. “Restart” button

e. “Boiler rinse” light

f. ”Water tank empty” light

g. Power cord reel button (depending on

model)

14. Power cord

1 • What water to use ?

Your iron has been designed to operate using

untreated tap water. If your water is very hard

(check with your local water authority) it is

possible to mix tap water with store-bought

distilled or demineralised water in the

following proportions: 50% untreated tap

water, 50% distilled or demineralised water.

2 • Preparing your steam

generator

Place your steam generator on a flat, stable,

horizontal heat-resistant work surface.

Open the water tank filler cover.

Using a jug, fill with a maximum of 1 litre of

water. Fill the boiler (fig.1), taking care that

the water does not spill over.

Close the water tank.

Completely unwind the power cord and the

steam cord from their storage space (fig.2).

Connect your generator to an earthed socket

(fig.3).

If water spills over, remove the excess water.

Before filling the tank, check that the gene-

rator is cold and unplugged.

TYPES OF WATER NOT TO USE: Heat

concentrates the elements contained in

water during evaporation. The types of

water listed below may contain organic

waste, mineral or chemical elements that

can cause spitting, brown staining, or

premature wear of the appliance: water

from clothes dryers, scented or softened

water, water from refigerators, batteries,

air conditioners, rain water, boiled, filtered

or bottled water. Also only use distilled or

demineralised water as advised above.

The first time the appliance is used, there

may be some fumes and smell but this is

not harmful. They will not affect use and

will disappear rapidly.

USE

PREPARATION

Due to the powerful steam output, a mesh type ironing board must be used to allow any excess

steam to escape and to avoid steam venting sideways.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest SGP 230 A1 IAN 71528 Seite 5

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Silvercrest SGP 230 A1 IAN 71528

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info