739903
67
Zoom out
Zoom in
Vorherige Seite
1/73
Nächste Seite
64
SHBS 1000 A1
GB
Operation with the power supply unit
If your hair and beard trimmer stops working during shaving due to discharged
or weak batteries, you can continue shaving by plugging in the power supply
unit
6
.
Plug the power supply unit plug
6
into the socket on the underside of the hair
and beard trimmer.
To avoid injuries and damage to the appliance, always switch the appliance off
before connecting it to the power supply.
Plug the power supply unit
6
(wide voltage range 100 - 240 V) in a power
socket complying with the appliance specifi cations.
After 1 - 2 seconds, you can switch the appliance on by pressing the ON / OFF
switch
3
. If the appliance does not start immediately, switch it off again and
wait around 1 minute before switching it on again.
If you want to charge the batteries without using the charging station
5
in this
manner you can only do this when the appliance is switched off .
Handling and use
Improving battery service life
We recommend completely discharging the batteries before recharging to ensure
a long battery service life. In order to completely discharge the batteries, run the
appliance until it stops completely.
Cutting hair
NOTE
Any hair to be cut should be clean and dry.
Brush the hair carefully through to remove any knots.
Place the hairdressing cape or cloth around your neck and throat to avoid
cut hair ends falling inside your collar.
First start using a longer cut length add-on
7
and then shorten your hair in
stages until it has the required length.
Cut length add-ons
7
:
Select a suitable cut length add-on
7
to match your required hair length (4 - 6
mm / 7 - 9 mm / 10 - 12 mm / 16 - 18 mm / 22 - 24 mm / 28 - 30 mm).
Click the selected cut length add-on
7
onto the trimmer block
from behind.
Ensure that both pins in the cut length add-on
7
correctly locate into the side
cutouts in the trimmer head holder.
IB_86722_SHBS1000A1_LB1.indb 64IB_86722_SHBS1000A1_LB1.indb 64 18.03.13 16:4118.03.13 16:41
67

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Silvercrest SHBS 1000 A1 IAN 86722 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info