575480
40
Zoom out
Zoom in
Vorherige Seite
1/58
Nächste Seite
38
4. Unpacking, setting up and inserting the battery
4.1 Setting up the appliance
Note! As the appliance and heating coils
are supplied with a thin film of grease, there
might be a small amount of smoke and
odour the first time the appliance is used.
This is not harmful and will stop after a short
while. Please ensure meanwhile that there is
sufficient ventilation.
1. Unpack the appliance from the
packaging.
2. Remove the transport packaging.
Note: There is a piece of corrugated
cardboard positioned between the
appliance and the base 9. This must also
be removed.
3. Check that the appliance shows no signs
of damage.
Warning! Ensure that there is suf-
ficient distance from the wall, fix-
tures and other appliances. The
distance must be at least 1.5 m to
exclude the risk of fire.
4. Select a location that complies with the
safety information (see “3. Safety infor-
mation” on page 35).
5. Select a location where the flow of hot
air is not directly aimed at people, ani-
mals or plants.
6. Plug the mains plug into a wall socket
that complies with the technical data.
Note:The appliance consumes up to
10 amperes of current (2,000 watts). If
you have plugged other power consu-
mers into the same circuit, check that the
maximum load for the installed fuse is
not exceeded, as otherwise the fuse will
trip.
4.2 Inserting the battery
If the appliance is new or the battery in the
remote control is flat, a new type CR2032
battery must be inserted.
1. Press the catch
towards the
middle and pull
out the battery
compartment.
2. Remove the old
battery if present.
Note: Please observe the instructions for
disposal (see “8.2 Disposable/recharge-
able batteries” on page 42).
3. Insert a new battery.
Note: Ensure the correct polarity (+/–)
when inserting the battery. The correct
polarity is marked on the battery com-
partment.
4. Slide the battery compartment back in
again.
RP66253 mit FB LB5 Seite 38 Mittwoch, 11. Mai 2011 11:56 11
40

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Silvercrest SHLF 2000 A1 - IAN 66253 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Silvercrest SHLF 2000 A1 - IAN 66253

Silvercrest SHLF 2000 A1 - IAN 66253 Bedienungsanleitung - Deutsch, Holländisch, Französisch, Italienisch - 46 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info