Bedienungsanleitung Silvercrest SKRP 1000 A1 IAN 58821 (Seite 42 von 62) (Englisch, Portugiesisch, Spanisch)

737618

Zoom out

Zoom in

Vorherige Seite

1/62

Nächste Seite

- 40 -

present) must be removed and then re-

inserted.

Information regarding the

handling of batteries

The appliance uses a battery for memo-

ry conservation. For the handling of bat-

teries please observe the following:

Riskofexplosion!

• Never subject batteries to excessive heat,

such as direct sunlight, re, etc. Do not

recharge the batteries.

• Never open batteries, never solder or

weld batteries. The risk of explosions

and injuries exists!

• Non-observance of the correct polarities

when inserting the battery may cause

an explosion. The battery may only be

replaced by one of the same or an

equivalent type.

• Regularly check the condition of the bat-

teries. Leaking batteries can cause dam-

age to the appliance.

• If you do not intend to use the appliance

for an extended period, remove the bat-

teries.

• Should the batteries leak, put on a pair

of protective gloves and clean the battery

compartment and terminals with a dry

cloth.

 Important!

No liability/warranty will be consid-

ered for damage to the Kitchen Radio

caused by the eects of moisture, water

penetration or overheating!

The appliance components

q Mounting plate/Baseplate

w Power cable

e Wire aerial

r Display

t–i M1–M4 - Memory buttons M1–M4

o MEM/AMS - to save and automatically

search for and save radio

stations

a MEM.SCAN - automatic recall of saved

radio stations

TIMER - controls the timer

programming

d Illuminated clamp strip

f AL2/VOL — - controls the alarm function 2

- Volume reduction

g AL1/VOL + - controls the alarm function 1

- Volume increase

h USER/BAND - User switching,

Radio waveband switching

LIGHT/ - controls the display and

DIMMER clamp strip illumination

k MODE/ - recalls the settings,

LOCK Button lock

l DOWN - Selection button down

1( UP - Selection button up

Battery compartment

2! ON/AOT/ - Switch the radio on/o

OFF controls the switch o timer

Setting up the appliance

First take all appliance components from the

packaging and remove all packing foil and

tape.

Inserting the battery

By inserting the batteries you will avoid the

loss of programmed times and alarm timings

in the event of a possible power outage.

The batteries ensures that the internal clock

continues to run even during a power failure.

When power is restored the correct time ap-

pears automatically in the display r.

Note:

The appliance can also be operated

without a battery.

1. Open the cover of the battery compart-

ment 2) on the underside of the appliance

by turning the cover with a coin to the left

and the limit stop and then lifting it.

2. Now place the battery of the type

CR2032 (supplied) in the battery com-

partment 2). The side with the marking +

should face upwards.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest SKRP 1000 A1 IAN 58821 Seite 42

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Silvercrest SKRP 1000 A1 IAN 58821

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info