Bedienungsanleitung Silvercrest SPWG 180A2 - IAN 307246 (Seite 16 von 52) (Deutsch, Englisch, Holländisch, Französisch, Polnisch)

694750

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

16 GB/IE

Replacing the battery

(see Fig. G)

1. Turn the product over and place it on a soft

underlay to avoid scratching the surface.

Replace the battery when the product is not in use

3. Open the battery compartment cover

described in chapter “Initial use“.

4. Remove the drained battery by pulling the lo-

cking tab

until the battery is automatically

released. Remove the battery from the battery

compartment

Note: The LC display

will show then to

replace the battery. When standing on the pro-

duct if the battery is low, the LC display

will

display “Lo” (see Fig. C) and the product will

automatically switch oﬀ.

Note: When the product displays “Lo”, replace

the drained battery with a new battery of the

type speciﬁed under “Technical data“.

5. Insert a new battery in the battery compart-

ment

. Be sure to insert the battery correctly,

with the “+” pole up. The battery must be

pushed into the battery compartment

until

secured in place by the locking tab

6. Close the battery compartment

as described

in chapter “Initial use“.

Setting the units of weight

Note: The standard unit of weight is kilogram (kg).

The factory default setting for the product as sup-

plied is “kg”.

Press the kg / lb / st button

to select the unit

of weight. The units will be displayed in the

LC display

as follows:

Kilogram (kg): see Figure A

Pound (lb): see Figure E

Stone (st): see Figure F

Switching on your product /

measuring your weight

Tip: Weigh yourself at the same time of day

(preferably in the morning) after visiting the toilet,

with an empty stomach and without clothing to

ensure that your results are compatible.

Place the product down on a solid, ﬂat horizon-

tal surface.

Step on to the product.

Place even weight on each leg.

If at all possible stand on the same areas of the

platform each time and do not move. Moving

during the weighing process can lead to

discrepancies in the results.

The product will start to measure immediately.

After blinking 3 times, the weight display will

display the result, as shown in, for example, Fig. B.

Note: If the product shows “oL” (see Fig. D), it

signals that the product is overloaded. Observe

the maximum capacity of 180 kg (396 lb / 28 st).

Step oﬀ the platform

. The product switches

oﬀ automatically after about 10 seconds. Until

then the weight measurement remains visible.

Note: After a change of location and follow-

ing every battery change, the product must be

re-calibrated. To do this, proceed as follows:

Step onto the product. The product will show

you an incorrect measuring result. Step oﬀ the

platform

. The product will calibrate auto-

matically.

Wait until the product switches oﬀ automatically.

Step onto the product once again. The product

will show you the correct measuring result.

Troubleshooting

This product has delicate electronic components.

This means that if it is placed near an object

that transmits radio signals, it could cause inter-

ference. If the LC display

indicates a problem,

move such objects away from it.

Electrostatic charge can lead to the product

failing. In cases of the product failing to work

remove the batteries for a short while and then

replace them.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest SPWG 180A2 - IAN 307246 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info