Bedienungsanleitung Silvercrest SSDMD 600 A1 - IAN 287485 (Seite 22 von 100) (Deutsch, Englisch, Holländisch, Französisch, Portugiesisch, Spanisch)

684864

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

fruits (e.g. cherries, peaches, apricots)

must be removed before blending.

~ In order to avoid damage to the device,

interrupt the blending process immedi-

ately if the blades of the blade assembly

do not turn at all or only with difficulty.

Pull out the mains plug and investigate

whether there is an obstruction in the

blender jug or whether the contents are

too tough. Also check whether the de-

vice is assembled correctly.

~ Never mix food on an oil basis such as

poppy seed or nuts (for instance for

poppy seed or nut butter) for more than

60 seconds, since otherwise the motor

may overheat and can be damaged.

~ Do not operate the device when it is

empty, as this causes the motor to over-

heat and may result in it being dam-

aged.

~ The device is designed for a maximum

operating period of 3 minutes without

interruption.

After this, the device must remain

switched off until it has cooled down to

room temperature.

~ Only use the original accessories.

All parts except for the motor block are

dishwasher-safe up to 70 °C.

~ Do not use any astringent or abrasive

cleaning agents.

~ The device is fitted with non-slip plastic

suction feet. As furniture is coated with

a wide array of varnishes and synthet-

ics, and is also treated with different

care products, it cannot be fully ruled

out that some of these materials contain

ingredients that could attack and soften

the non-slip plastic suction feet. If neces-

sary, place a non-slip mat under the de-

vice.

4. Items supplied

1 blender jug|4 (min 250 ml –

max|1.75 litres filling volume)

1 motor block|7

1lid|2

1 measuring jug (30, 45, 60 ml)|1

1 copy of the user instructions

5. How to use

• Remove all packing material.

• Check to ensure that all parts are pres-

ent and undamaged.

• Clean the device prior to its first

use! (see “Cleaning” on page 23)

• Place the device on a dry, level and

non-slip surface.

6. Assembly

DANGER! Risk of injury from

cutting!

~ The blade assembly|6 is sharp. Handle

it with care.

~ Do not insert the mains plug|10 into a

wall socket until the jug blender has

been completely assembled.

NOTES:

• The device is equipped with two

safety

switches

and must be locked

twice. The device can only be put into op-

eration when the blender jug

and the

lid|

are in position and locked. Should it

be possible to switch on the device also

without the blender jug

in place, do

not operate the device any longer. Con-

tact our Service Centre by

telephone

(see “Warranty of the

HOYER Handel GmbH” on page 27).

• If the blender jug|4 is removed during

operation, the device will switch off auto-

matically. Adjust the control dial|9 so

that the marking is pointing to 0 in order

to switch off the device before placing

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest SSDMD 600 A1 - IAN 287485 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info