Bedienungsanleitung Silvercrest SST 100 A1 - IAN 293926 (Seite 31 von 78) (Deutsch, Englisch, Holländisch, Französisch)

773468

Zoom out

Zoom in

Vorherige Seite

1/78

Nächste Seite

GB/IE 31

• It is necessary to repair the product if it has

been damaged in any way, for example, if the

housing is damaged, if liquid or objects have

penetrated the device or if the product has

been exposed to rain or moisture.

• Repair work is also required if the device is

not working properly or has been dropped.

If smoke is produced, or there are any

unusual sounds or smells, turn the product oﬀ

immediately. In such cases, the product should

not be used until they have been inspected by

authorised service personnel. Only have the

device repaired by qualiﬁed personnel. Never

open the housing of the product.

• Only use a clean, dry cloth for cleaning the

product and never use any corrosive liquids.

Use a slightly moistened cloth and a mild

cleaning agent to remove stubborn dirt.

Troubleshooting

To keep the warranty valid, never try to repair the

system yourself. If you encounter problems when

using this unit, check the following points before

requesting service.

No power

• Ensure that the AC cord of the apparatus is

connected properly.

• Ensure that there is power at the AC outlet.

• Press the standby button to turn the unit on.

Remote control does not work

• Before you press any playback control button,

ﬁrst select the correct source.

• Reduce the distance between the remote

control and the unit.

• Insert the battery with its polarities (+/-)

aligned correctly.

• Replace the battery.

• Aim the remote control directly at the sensor on

the front of the unit.

Clock setting erased

• Power has been interrupted or the power cord

has been disconnected.

• Reset the clock.

Tuning in a station

Press and hold the / buttons on the remote

control, the frequency changes down or up

automatically until a station is found.

Note:

The search may not stop at a station with a very

weak signal.

Press the / buttons on the remote control

repeatedly until you ﬁnd the station you want.

Each press of the / buttons will adjust the

frequency by 0.1 MHz. If reception is still poor, try

to move the radio to another location.

Presetting stations manually

You can preset up to 20 FM stations.

1. Tune in the desired station, then press the

PROG button on the remote control.

2. Press the PRE-/PRE+ buttons on the remote

control to select the preset number.

3. Press the PROG button on the remote control

to store the station.

4. Repeat above steps 1 to 3 for each station

you want to store in memory with a preset

number.

Storage when not in use

Store the unit in a dry location to protect it from

dust and direct sunlight.

Cleaning

• Switch the product oﬀ, remove all plugs before

cleaning!

• No acid, chaﬁng or solvent cleaning agents

should be used or the product can be

damaged.

• Only clean the outside of the product using a

soft, dry cloth!

• For persistent soiling, a mild cleaning agent

can be used.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest SST 100 A1 - IAN 293926 Seite 31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info