Bedienungsanleitung Silvercrest STGR 1600 A1 IAN 61121 (Seite 24 von 32) (Englisch, Italienisch, Portugiesisch, Spanisch)

737539

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

- 22 -

Taking it into use

Before taking the table grill into use for the first time

clean it as described in the chapter “Cleaning and

care”.

Usage / grilling may only take place with the catch-

ment pan

intended for the purpose.

The voltage of the power source must tally with the

details given on the rating plate of the appliance.

Handling the grill

A good and even heat distribution is assured by the

integrated heating element

under the grill

Cleaning is made easier by the non-stick coating,

which prevents the adhesion of grillables.

• Place the assembled stand on a level surface.

Bear in mind that there needs to be a mains power

socket in the close vicinity.

• Fill the catchment pan

up to the max. marking

with water (ca. 1.3 ltrs). You can thus prevent the

burning-on of fats falling from the grillables and

make the subsequent cleaning of the appliance

easier.

• Install the splatter protection shield

on one

side (the later rear side) of the grill bars

should you be grilling greasy grillables. Additio-

nally, it serves well as a windbreak. Insert the

three tenons of the splatter protection shield

into the holes provided on one side of the grill

bars

. To do this, the splatter protection shield

must be lightly flexed.

• Place the grill bars

on the catchment pan

such that they are firmly seated.

• Place the grill on the stand. The 4 mounting pegs

on the top plate of the stand must encroach into

the depressions on the underside of the grill.

The grill must sit firmly on the stand.

Notice

You can also use the grill without the stand:

Place the grill on an absolutely level and even sur-

face. The surface must be insensitive to heat.

Otherwise, it could cause damage to the surface.

• Check to ensure that the grill bars

are correctly

placed onto the catchment pan

(see Fig.

• Insert the power cable with thermostat

into

the appliance such that the control lamp

is fa-

cing upwards. Then insert the plug into a mains

power socket.

• Adjust the thermostat

to the desired temperature

setting. The grill starts to warm up and the indi-

cator lamp

glows.

• As soon as the indicator lamp

goes out the

grill has reached the adjusted temperature and

is ready for use.

Notice

Subject to the ambient temperature, it can happen

that the control lamp

does not go out with the

thermostat setting “M”.

• After a warm-up phase of approx. 15 minutes

the grill is ready for use.



Risk of injuries

When the grill has warmed up, take hold of it ONLY

with the heat-insulated handles

Thermostat adjustments

Level 0 Grill switched off

Level 0 - 1 Grill switched on; low temperature

Level 1 - 3 Grill switched on; medium tem-

perature (e.g. vegetables)

Level 3 - M (Max) switched on; high temperature

(e.g. meats)

IB_61121_STGR1600A1_LB5 23.11.2010 8:58 Uhr Seite 22

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest STGR 1600 A1 IAN 61121 Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Silvercrest STGR 1600 A1 IAN 61121

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info