Bedienungsanleitung Silvercrest STK 600 A1 IAN 75439 (Seite 48 von 54) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

739755

Zoom out

Zoom in

Vorherige Seite

1/54

Nächste Seite

wise it may overflow during the boiling

process.

WARNING!

• Never put alcohol, sugar or milk into

the glass pot8!

• Always allow the glass pot8 to cool be-

fore filling it with cold water. Large tem-

perature differences create large stresses

in the glass and may cause it to shatter.

1. Remove the glass pot8 from the

base14.

2. Open the lid6.

3. Remove the boiling system5.

4. Hold the boiling chamber4 tightly with

one hand, and pull the overflow1 up-

wards until the screen2 has opened the

boiling chamber, and then place the

boiling system5 on a level surface.

5. Fill the glass pot8 with the desired

quantity of water. Never fill with water

above the MAX marking9, and never

below the MIN marking10.

6. Place the desired quantity of tea into the

boiling chamber4.

7. Insert the boiling system5 into the glass

pot8. The recess in the boiling cham-

ber4 should be pointing towards the

handle7.

8. Close the boiling chamber4 by press-

ing down the screen2 at the over-

flow1. Make sure while doing so that

the riser pipe3 slots into the recess in

the bottom of the pot.

9. Close the lid6 of the glass pot8.

10.Use the On / Off switch11 to switch

the device on (I). The control light12

and the On / Off switch will light up.

You can interrupt the boiling process at

any time by switching off the device at

the On / Off switch (O) or by removing

the glass pot8 from the base14.

Depending on the volume of water, the boil-

ing process takes 6 - 10 minutes. After the

boiling process is complete (control light12

goes out), the device automatically switches

to the heating function. If the glass pot8 is

left for a long time and the contents cool

down, the tea kettle will reboil the contents.

During this process the control light will light

up again. As the contents will flow through

the boiling system5 again during this proc-

ess, you should remove it after the first boil-

ing process.

NOTE:

• Do not use green tea in the tea kettle.

The tea kettle generates a higher boiling

temperature than is required for steep-

ing green tea. The tannins released

would make the tea taste bitter.

• For proper enjoyment, drink the tea after

it has brewed the first time. If the tea is

kept hot for a long time, or if it is re-

boiled, water will evaporate and the tea

will become stronger and bitter.

• For stronger tea, add more tea to the

glass pot8; for weaker tea, add less.

• The strength of the tea depends on the

volume of water, the type of tea and the

quantity of tea used.

7. Overheating

protection

If there is no water or inadequate water in

the glass pot8 and the device is neverthe-

less switched on, this will activate the over-

heating protection, which will switch off the

heating element inside the device. The On /

Off switch11 will continue to be lit, howev-

er the device will no longer heat the con-

tents.

1. Switch off the device with the On / Off

switch11.

2. Allow the device to cool down.

3. Press the Reset button13 at the under-

neath of the glass pot8.

The device can now be reused.

__RP75439_B1.book Seite 46 Mittwoch, 27. Juni 2012 4:11 16

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Silvercrest STK 600 A1 IAN 75439 Seite 48

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info