572713
49
Zoom out
Zoom in
Vorherige Seite
1/66
Nächste Seite
|
49
Autopilot | NSS Installation Manual
If the value is set too high the overshoot will increase and the steering will be
unstable.
Counter rudder
Counter rudder is the amount of rudder used to try to prevent the boat from yawing
around the set course. Higher counter rudder settings result in more rudder being
applied.
The best way of checking the value of the Counter rudder setting is when making
turns.
The  gures illustrate the e ects of various Counter Rudder settings;
A: Counter rudder too low; overshoot response
B: Counter rudder too high; sluggish and creeping response
C: Correct setting or counter rudder; ideal response
ABC
Auto trim
This parameter de nes how fast the autopilot shall correspond after having registered
a heading error.
The standard value is 40 seconds which should work well on most boats. Rule of
thumb: Set to same value (seconds) as the boat’s length in feet. On boats operating
on VRF the value should be set to 20 seconds.
Rate limit
Sets the maximum allowed rate of turn.
The value should be kept at 6.0°/second unless there is a need for more rapid
response in turns.
Minimum rudder
This parameter  lters small rudder commands to prevent high rudder activity.
Some boats may have a tendency to not respond to small rudder commands around
the course keeping position because of a small rudder, a rudder deadband, whirls/
disturbance of the water-stream passing the rudder or it is a single nozzle water jet
boat.
By increasing the Minimum rudder parameter you may improve the course keeping
performance on some boats. This will however increase the rudder activity.
Minimum wind angle to port and starboard
These parameters should be set identical to the minimum apparent wind angle that
will keep the sails well shaped and give an acceptable thrust. The parameters will vary
from boat to boat.
The settings are used for the tack-prevent function. They also applies when the autopi-
lot is operating in WindNAV mode. Refer to the
Operating the autopilot section.
You can select di erent minimum wind angles for port and starboard. The di erence
between port and starboard will be taken into account when calculating the Distance
To Turn (DTT).
49

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

simrad-nss-chartplotter

Suche zurücksetzen

  • wie aktiviert man bei NSS 12 die Anzeige der AIS-Information in der Karte des Plotters
    Eingereicht am 21-7-2022 18:41

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Simrad NSS Chartplotter wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Simrad NSS Chartplotter

Simrad NSS Chartplotter Bedienungsanleitung - Englisch - 96 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info