Bedienungsanleitung Sitecom dc 210 wired router (Seite 41 von 43) (Englisch)

432046

Zoom out

Zoom in

Vorherige Seite

1/43

Nächste Seite

Glossery

Default Gateway (Router): Every non-router IP device needs to configure a

default gateway’s IP address. When the device sends out an IP packet, if the

destination is not on the same network, the device has to send the packet to its

default gateway, which will then send it out towards the destination.

DHCP: Dynamic Host Configuration Protocol. This protocol automatically gives every

computer on your home network an IP address.

DNS Server IP Address: DNS stands for Domain Name System, which allows

Internet servers to have a domain name (such as www.Broadbandrouter.com) and

one or more IP addresses (such as 192.34.45.8). A DNS server keeps a database of

Internet servers and their respective domain names and IP addresses, so that when

a domain name is requested (as in typing "Broadbandrouter.com" into your Internet

browser), the user is sent to the proper IP address. The DNS server IP address used

by the computers on your home network is the location of the DNS server your ISP

has assigned to you.

DSL Modem: DSL stands for Digital Subscriber Line. A DSL modem uses your

existing phone lines to transmit data at high speeds.

Ethernet: A standard for computer networks. Ethernet networks are connected by

special cables and hubs, and move data around at up to 10/100 million bits per

second (Mbps).

Idle Timeout: Idle Timeout is designed so that after there is no traffic to the

Internet for a pre-configured amount of time, the connection will automatically be

disconnected.

IP Address and Network (Subnet) Mask: IP stands for Internet Protocol. An IP

address consists of a series of four numbers separated by periods, that identifies a

single, unique Internet computer host in an IP network. Example: 192.168.2.1. It

consists of 2 portions: the IP network address, and the host identifier.

The IP address is a 32-bit binary pattern, which can be represented as four cascaded

decimal numbers separated by “.”: aaa.aaa.aaa.aaa, where each “aaa” can be

anything from 000 to 255, or as four cascaded binary numbers separated by “.”:

bbbbbbbb.bbbbbbbb.bbbbbbbb.bbbbbbbb, where each “b” can either be 0 or 1.

A network mask is also a 32-bit binary pattern, and consists of consecutive leading

1’s followed by consecutive trailing 0’s, such as

11111111.11111111.11111111.00000000. Therefore sometimes a network mask

can also be described simply as “x” number of leading 1’s.

When both are represented side by side in their binary forms, all bits in the IP

address that correspond to 1’s in the network mask become part of the IP network

address, and the remaining bits correspond to the host ID.

For example, if the IP address for a device is, in its binary form,

11011001.10110000.10010000.00000111, and if its network mask is,

11111111.11111111.11110000.00000000

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Sitecom dc 210 wired router Seite 41

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info