2. Basic Setup
System Requirements
• To use the wired LAN interface, a standard 10/100BaseT hub or switch and network
cable is required.
• To use the Wireless interface on the Wireless IP Camera with MPEG4/MJPEG, other
Wireless devices must be compliant with the IEEE802.11b or IEEE802.11g
specifications. All Wireless stations must use compatible settings.
The default Wireless settings are:
Mode
SSID
Security
Channel
Infrastructure
Sitecom
Disabled
Auto
Installation - Network Camera
1. Assemble the Camera
Screw the supplied antenna to the mounting point on the rear.
Attach the Camera Mount to the camera.
2. Connect the LAN Cable
Connect the Network Camera to a 10/100BaseT hub or switch, using a standard LAN
cable.
For the WL-404, plugging in the LAN cable will disable the Wireless
interface. Only 1 interface can be active at any time.
The LAN cable should only be connected or disconnected when the
camera is powered OFF. Attaching or detaching the LAN cable while the
camera is powered on does NOT switch the interface between wired and
wireless.
The first time you connect to the camera, you should connect the LAN
cable and configure the Network Camera with appropriate settings. Then
you can unplug the LAN cable and power off the camera. The Network
Camera will be in wireless interface when you power on the camera
again.
3. Power Up
Connect the supplied 5V power adapter to the Network Camera and power up. Use only
the power adapter provided. Using a different one may cause hardware damage.
4. Check the LEDs
• The Power LED will turn on briefly, then start blinking. It will blink during startup,
which takes 15 to 20 seconds. After startup is completed, the Power LED should
remain ON.
• The Network LED should be ON.
