479914
6
Zoom out
Zoom in
Vorherige Seite
1/128
Nächste Seite
6
In case of electrical or mechanical
malfunction, immediately switch off
the tool or unplug charger from power
source
SKIL can assure fl awless functioning
of the tool only when original
accessories are used
The tool/charger is not intended for
use by persons (including children)
with reduced physical, sensory or
mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision or
instruction concerning use of the tool/
charger by a person responsible for
their safety
Ensure that children do not play with
the tool/charger
Be careful not to drive into areas
where electrical wires may be
contacted
Ensure that switch B 2 is in the
middle (locking) position before
making any adjustments or changing
accessories as well as when carrying
or storing the tool
CHARGING/BATTERIES
Charge battery only with the charger
that is supplied with the tool
Do not expose tool/charger to rain
Never charge battery outdoors 4
Store tool/charger in locations where
temperature will not exceed 40°C or
drop below 0°C
Batteries may explode when disposed
of in fi re, so do not burn battery for
any reason
Do not use charger when cord or plug
is damaged; cord or plug should be
replaced immediately at one of the
offi cially registered SKIL Service
Stations
Do not disassemble charger or tool
Do not attempt to recharge non-
rechargeable batteries
USE
• Charging battery 5
- battery of new tools is not fully
charged
- after approximately 5 hours the
battery is fully charged
! unplug the charger from the tool
after charging period has ended
thereby lengthening the service
life of the battery
IMPORTANT:
- while charging, the charger and the
battery may become warm to touch;
this is normal and does not indicate
a problem
- do not charge at temperatures
below 0°C and over 40°C; this will
seriously damage the battery as well
as the charger
! a battery that is new or has not
been used for a longer period
does not develop its full capacity
until after approximately 5
charging/discharging cycles
- do not repeatedly recharge the
battery after only a few minutes of
operation; this may result in a
reduction of operating time and
battery effi ciency
- the battery must be kept separate
from the natural environment and
should not be disposed of as normal
domestic waste (symbol 6 will
remind you of this when the need for
disposing occurs)
! prior to disposal protect battery
terminals with heavy tape to
prevent short-circuit
- if you anticipate long periods of non-
use for the tool, it is best to unplug
the charger from its power source
• On/off 7
Changing direction of rotation 8
- when not properly set in left/right
position, switch A 2 cannot be
activated
! change direction of rotation only
when tool is at a complete
standstill
• Changing bits 9
- push bit to end position in bitholder
! do not use bits with a damaged
shank
• Automatic spindle-lock
Allows you to manually tighten or
loosen screws, when necessary 0
APPLICATION ADVICE
Use the appropriate bits !
! do not use damaged bits
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Skil 2148 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info