Bedienungsanleitung Skoda Amundsen - 2014 (Seite 13 von 30) (Englisch)

678547

Zoom out

Zoom in

Vorherige Seite

1/30

Nächste Seite

Introductory information about the CD mode

Insert CD

›

Insert a CD, with the labelled side facing up, into the CD slot

until it is auto-

matically drawn in. The play function will start automatically.

Removing the CD

›

Press the button



– die CD is ejected.

If the ejected CD is not taken out within 10 seconds, it will be retracted again for

safety reasons.

CD not legible

If a CD is inserted which cannot be read by the unit, a pop-up window is displayed

with a note. Press the function key

, the CD is moved to the removal position.

WARNING

The CD player is a laser product. On the manufacturing date, this device was

classified as a class 1 laser product in accordance with the national/interna-

tional standards DIN EN 60825-1: 2008-05 and DHHS Rules 21 CFR,

subchapter J The laser used in this class 1 laser product is so weak that there

is no risk of danger when operated correctly. This product is designed such

that the laser is restricted to the inside of the unit. However, the installed la-

ser could be classified in a higher class were the housing to be removed. For

this reason, never remove the housing from the unit.

CAUTION

■

Only audio-CDs (CD-A) and MP3-CDs can be played in the internal drive. Never

place DVDs into the internal drive – irreparable damage may result.

■

Never insert CDs with the designation “Do not insert in drives without a drawer”

or Eco Disc into the internal drive.

■

After pressing the button



there is a time delay of a few seconds before the

CD is ejected. During this time the lock in front of the CD slot is open.

■

Be sure to wait until the CD has been fully ejected before you try to insert a new

CD. Otherwise you can damage the drive inside the unit.

■

A dirty, mechanically damaged, unreadable or incorrectly inserted CD can cause

playback problems. For this reason, the disc may not be playable or may cause the

CD to jump. Check the CD and insert it properly into the unit. Should the problem

persist, try using another CD and visit a specialist garage if necessary.

■

If the inside temperature of the unit is too high, no CDs will be accepted. The

unit switches into the last active operating mode.

■

Never use liquids such as petrol, paint thinner or record cleaner to clean the sur-

face of the CD - this may cause damage.

■

Never expose the CD to direct sun light!

■

Only write on the CD with appropriate writing tools.

■

Do not affix anything to the CD!

Note

■

Uneven road surfaces and strong vibrations may cause the CD to jump.

■

In cold weather or after rain showers, moisture (condensate) may deposit in the

unit. This can effect the CD jump or impair the play function. In that case, wait un-

til the moisture has dissipated.

■

Should a CD be dirty, never clean it in a circular motion, but instead work from

the inside out. Use a soft, lint-free cloth. For heavy stains, we recommend that

you clean the CD with a commercially available CD cleaner and allow it to dry.

■

It is possible that CDs protected by copyright and home-made CD-R and CD-RW

will not be played back at all or only in certain circumstances.

■

Please also note the additional information for MP3 mode.

■

The national copyright laws that apply in your country must be observed.

■

The CD player does not contain parts that need to be serviced or repaired. In the

case of a defective CD player, please visit a specialist garage.

■

If the ejected CD is not taken out, it will be retracted again for safety reasons.

■

If a TP station was set before changing to CD mode, CD playback will be inter-

rupted during the traffic news and the device switches to radio mode. Once the

traffic news has ended, CD playback will resume.



SD memory card

Inserting an SD memory card

›

Insert the SD memory card into the memory card slot

with the slanted edge

to the front right until it “locks into place”. The play function will start automati-

cally.

Removing an SD memory card

›

In the “System and sound settings” menu, choose the menu point “Remove SD

card” » page 7, System and sound settings.

›

Press on the inserted SD memory card. The SD memory card “jumps” into the

eject position.



MEDIA mode

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Amundsen - 2014 Seite 13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Amundsen - 2014

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info