Bedienungsanleitung Skoda Amundsen 2013 (Seite 71 von 83) (Englisch)

618759

Zoom out

Zoom in

Vorherige Seite

1/83

Nächste Seite

Range (if the estimated range is less than 300 km, the vehicle starts to ap-

proach the symbol: )

Vehicle representation (the zones of the vehicle are shown in different col-

ours, corresponding to any warning messages that occur. The warning mes-

sages are displayed once you touch vehicle)

■

Driving data - Display travel data » Fig. 45

You can display one of three trip memories on the screen:

■

Since start - Driving data for the individual trip

■

Long-term - Long-term driving data

■

Since refuelling - Data since last refuelling

You can switch between the individual travel data memories





■

Convenience consumers - Display up to three devices which use the largest

share of fuel and display the fuel consumption required to run all conv. consum-

ers » Vehicle Owner's Manual, chapter Commercial driving and environmental

compatibility

■

Vehicle status - Displays vehicle status» Fig. 45 or tire pressure monitoring in-

formation

■

Vehicle status - Display vehicle status information

■





/ - No message/warnings relating to vehicle status or number of mes-

sages (if there is only one message, one warning message text is displayed)

■



- Display information about the status of the START-STOP system

■

TPMS - Function of the tire pressure monitor » Fig. 46

■



SET - Start a new calibration process

You can switch between the individual menus





Note

For more information on the warning messages concerning the vehicle status and

information on the START-STOP system, see the » Vehicle Owner's Manual.



Auxiliary heater and ventilation

Fig. 47 Auxiliary heater: Main menu/set preset time

First read and observe the introductory information given on page 67.

Press the

CAR

SETUP

button on the Climatronic unit →



Set-up

Departure time: Day and time when the vehicle is to be ready for use » Fig. 47

Heating/ventilation: Set the operating mode

Select the preset time, switch off the preset time

Set the preset times 1 to 3 and the duration (10 - 60 minutes)

When the heating or ventilation is running, the windows are highlighted in

red or blue

Note

■

Only one preset time can be active. The activated preset time will be deactiva-

ted again after it has started automatically. For the next start, activate one of the

preset times.

■

In the selection of the day in the preset time, there is an option between Sun-

day and Monday without the specified day. If this setting is made, the vehicle will

be ready for use at the selected time, regardless of the current day.

■

The system in operation switches off on expiration of the operating duration or

can be deactivated by pressing the direct on/off symbol  or via the radio remote

control.

■

If a different time is set » page 20, Time and date settings, the activated preset

time is automatically deactivated. The preset time must be reactivated.





Vehicle systems

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Amundsen 2013 Seite 71

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Amundsen 2013

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info