Bedienungsanleitung Skoda Citigo - 2013 (Seite 36 von 164) (Englisch)

678230

Zoom out

Zoom in

Vorherige Seite

1/164

Nächste Seite

The display is updated regularly while you are driving.

Current driving speed

The current speed, which is identical to the display of the speedometer

» Fig. 19 on page 28 is displayed.

Coolant temperature

The current coolant temperature is displayed.

Warning against excessive speeds

Set the speed limit, for example, for the maximum permissible speed in

town » page 33, Warning at excessive speeds.

Warning at excessive speeds

Read and observe on page 31 first.

Adjust the speed limit while the vehicle is stationary

›

Select the menu item



(warning when limit is exceeded).

›

Activate the speed limit option by confirming this menu item (the value flash-

es).

›

Set the desired speed limit, e.g. 50 km/h.

›

Store the speed limit by confirming the set value, or wait several seconds;

your settings will be saved automatically.

This allows you to set the speed in 5 km/h intervals.

Adjusting the speed limit while the vehicle is moving

›

Select the menu item



(warning when limit is exceeded).

›

Drive at the desired speed, e.g. 50 km/h.

›

Confirm the current speed as the speed limit.

If you wish to adjust the set speed limit, you can do so in 5 km/h intervals (e.g.

the accepted speed of 47 km/h increases to 50 km/h or decreases to 45 km/h).

›

Store the speed limit, or wait several seconds; your settings will be saved au-

tomatically.

Change or disable speed limit

›

Select the menu item



(warning when limit is exceeded).

›

By confirming the stored value, the speed limit is disabled.

›

By reconfirming, the option to change the speed limit is activated.

If the set speed limit is exceeded, an audible signal will sound as a warning. At

the same time the message



(warning against excessive speed) appears on

the display with the set limit value.



The set driving mode remains stored even after switching the ignition on and

off.

Read and observe on page 31 first.

The time is set as follows.

›

Select the time display on the instrument cluster » page 31, Operation.

›

Press the button

» Fig. 19 on page 28 and keep it pressed down until the

time display appears.

›

Press button

to change the value. For quick value change, hold down the

button.

›

Press button

to select the minutes display until it flashes.

›

Press button

to change the value. For quick value change, hold down the

button.

›

Confirm the set value by pressing the button

again, or wait for around 5

seconds. The setting is saved automatically (the value stops flashing).

Warning lights



Introduction

This chapter contains information on the following subjects:



Handbrake 34



Braking system 34



Seat belt warning light 34



Alternator 34



Engine oil



Coolant 35



Automated transmission 35









Power steering 36



Electronic Stability Control (ESC) 36



Traction Control System (TCS)



Antilock brake system (ABS) 37



Tyre pressure 37



Rear fog light 37



Exhaust inspection system 37



Engine performance check 38



Airbag system 38





Instruments and control lights

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Citigo - 2013 Seite 36

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Citigo - 2013

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info