Bedienungsanleitung Skoda Citigo - 2016 (Seite 116 von 160) (Englisch)

617556

116

Zoom out

Zoom in

Vorherige Seite

1/160

Nächste Seite

Checking the battery electrolyte level

Fig. 112

Vehicle battery: Electrolyte level

indicator

Read and observe and on page 113 first.

On vehicles with a vehicle battery fitted with a colour indicator, the electrolyte

level can be determined by looking at the change in the colour of this display.

Air bubbles can influence the colour of the indicator. For this reason carefully

knock on the indicator before carrying out the check.

Checking

Black colour – electrolyte level is correct.

Colourless or light yellow colour – electrolyte level too low, the battery must

be replaced.

For technical reasons, the electrolyte level cannot be checked on vehicles with

the designation “AGM” .

Vehicles with the START-STOPsystem are fitted with a battery control unit for

checking the energy level for recurring engine starts.

We recommend that you have the acid level checked regularly by a specialist

garage, especially in the following cases.

▶

High external temperatures.

▶

Longer day trips.

▶

After each charge.

Winter time

The vehicle battery only has a proportion of the starting power in lower tem-

peratures. A discharged vehicle battery may already freeze at temperatures

just below 0 °C.

We therefore recommend that you have the battery checked and, if necessary,

recharged by a specialist garage before the start of the winter.



Note

The battery acid level is also checked regularly by a specialist garage as part of

the inspection service.

Charging

Read and observe and on page 113 first.

A properly charged vehicle battery is essential for reliably starting the engine.

A charging operation can be performed if the following conditions are satis-

fied.

The engine is turned off.

The ignition is switched off.

All consumers are turned off.

The bonnet is open.

“Fast charging” with high currents

›

Disconnect both battery cables (first of all “negative”, then “positive”).

›

Attach the terminal clamps of the charger to the battery terminals (red =

“positive”, black = “negative”).

›

Plug the mains cable of the charger into the power socket and switch on the

device.

›

After charging has been successful: Switch off the charger and remove the

mains cable from the power socket.

›

Only then disconnect the charger's terminal clamps.

›

Reconnect the cables to the battery (first “positive”, then “negative”).

Charging with low voltages

It is not necessary to disconnect the cables from the battery if you recharge

the vehicle battery, for example from a mini-charger.

Refer to the instructions of the charger manufacturer.

A charging current of 0.1 multiple of the total vehicle battery capacity (or low-

er) must be used until full charging is achieved.

The vent plugs of the vehicle battery should not be opened for charging.







114

General Maintenance

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Citigo - 2016 Seite 116

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Citigo - 2016

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info