Bedienungsanleitung Skoda Citigo - 2016 (Seite 132 von 160) (Englisch)

617556

132

Zoom out

Zoom in

Vorherige Seite

1/160

Nächste Seite

›

Attach clamp

to the negative terminal of the battery supplying power

›

Attach the clamp

to a solid metal component firmly connected to the en-

gine block or to the engine block itself.

On vehicles with the START-STOPsystem the jump-start cable must be con-

nected to the engine earthing point » Fig. 125.

Starting engine

›

Start the engine on the vehicle providing the power and allow it to idle.

›

Start the engine of the vehicle with the discharged battery.

›

If the engine does not start, halt the attempt to start the engine after 10 sec-

onds and wait for 30 seconds before repeating the process.

›

Remove the jump start cables in the reverse order as attachment.

Both batteries must have a rated voltage of 12 V. The capacity (Ah) of the bat-

tery supplying the power must not be significantly less than the capacity of

the discharged battery in your vehicle.

Jump-start cables

Only use jump-start cables which have an adequately large cross-section and

insulated terminal clamps. Observe the instructions of the jumper lead manu-

facturer.

Positive cable – colour coding in the majority of cases is red.

Negative cable – colour coding in the majority of cases is black.

WARNING

■

Do not clamp the jump-start cable to the negative terminal of the dis-

charged battery. There is the risk of detonating gas seeping out the battery

being ignited by the strong spark which results from the engine being star-

ted.

■

The non-insulated parts of the terminal clamps must never touch each

other – there is a risk of short circuit.

■

The jump-start cable connected to the positive terminal of the battery

must not come into contact with electrically conducting parts of the vehicle

– there is a risk of short circuit.

■

Route the jump-start cables so that they cannot be caught by any rotat-

ing parts in the engine compartment.

Towing the vehicle

 Introduction

Fig. 126 Braided tow rope / Spiral tow rope

This chapter contains information on the following subjects:

Front towing eye 131

For towing, a braided tow rope is to be used » Fig. 126 -



When towing, the following guidelines must be observed.

Vehicles with manual transmission may be towed with a tow bar or a tow rope

or with the front or rear wheels raised.

Vehicles with automatic transmission may be towed in with a tow bar or a tow

rope or with the front wheels raised. If the vehicle is raised at rear, the auto-

matic gearbox is damaged!

Driver of the tow vehicle

›

Engage the clutch gently when starting off or depress the accelerator partic-

ularly gently if the vehicle is fitted with an automatic gearbox.

›

Only then approach correctly when the rope is taut.

The maximum towing speed is 50 km/h.

Driver of the towed vehicle

›

Switch on the ignition so that the steering wheel is not locked and so that

the turn-signal lights, windscreen wipers and windscreen washer system can

be used.

›

Take the vehicle out of gear or move the selector lever into position N if the

vehicle is fitted with an automated transmission.



130

Do-it-yourself

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Citigo - 2016 Seite 132

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Citigo - 2016

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info