678226
128
Zoom out
Zoom in
Vorherige Seite
1/160
Nächste Seite
The jacking points are located on the lower sill » Fig. 154.
Position the base plate of the jack with its full area resting on level ground
and ensure that the jack will fit in the jacking point when raised » Fig. 155 - .
Use the crank to raise the jack until its pawl covers the jacking
point» Fig. 155- .
Raise the vehicle until the wheel is a little off the floor.
WARNING
The following instructions must be observed, otherwise there is risk of in-
jury.
Ensure the vehicle cannot unexpectedly roll away.
Always ensure the base plate of the lifting jack cannot slip.
Place a wide and stable base material under the jack if on a loose surfa-
ces (e.g. gravel).
Place an anti-slip base material (e.g. a rubber mat) under the jack if on a
smooth surface (e.g. cobblestones).
Always raise the vehicle with the doors closed.
Never position any body parts (e.g. arms or legs) under the vehicle while
the vehicle is raised.
When the vehicle is raised, never start the engine.
CAUTION
It is important to ensure that the jack is correctly attached to the bar of the
lower beam – otherwise there is a risk of damage to the vehicle.
Breakdown kit
Introduction
The following information applies for the breakdown kit supplied ex-factory.
The breakdown kit can be used to seal punctures with a diameter of up to
about 4 mm.
A repair made using the breakdown kit is never intended to replace a perma-
nent repair on the tyre. Its purpose is to get you to the nearest specialist ga-
rage.
Replace the tyre that was repaired using the breakdown kit as soon as possi-
ble, or consult a specialist garage about repair options.
Do not remove foreign bodies which have penetrated into the tyre (e.g. nails).
Do not use the breakdown kit in the following cases.
The rim is damaged.
The outdoor temperature is below the minimum temperature indicated in
the instruction manual for the tyre filling bottle with sealant.
Tyre punctures greater than 4 mm.
Damage to the tyre wall.
The use-by date (see inflation bottle) has passed.
WARNING
If there is skin contact with the sealant wash the affected area immedi-
ately.
Observe the instructions provided in the puncture repair kit manufactur-
er's instructions for use.
Description of the breakdown kit
Fig. 156 Description of the breakdown kit
Read and observe on page 126 first.
The kit is located in a box under the floor covering in the luggage compart-
ment.
Sticker with speed designation “max. 80 km/h”/“max. 50 mph”
Valve remover
Inflation hose with plug
1
2
3
126
Do-it-yourself
128

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Skoda Citigo - 2017 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Skoda Citigo - 2017

Skoda Citigo - 2017 Bedienungsanleitung - Deutsch - 168 seiten

Skoda Citigo - 2017 Bedienungsanleitung - Holländisch - 168 seiten

Skoda Citigo - 2017 Bedienungsanleitung - Französisch - 172 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info