Bedienungsanleitung Skoda Rapid - 2013 (Seite 17 von 218) (Englisch)

678345

Zoom out

Zoom in

Vorherige Seite

1/218

Nächste Seite

The following message is shown in the MAXI DOT display.

ENGINE COOLANT PLEASE CHECK Log book!

Stop the vehicle, switch off the engine, check the level of the coolant » page 162,

and refill the coolant if necessary » page 163.

If the coolant is within the specified range, the increased temperature may be

caused by an operating problem at the radiator fan. Check the fuse for the radia-

tor fan, replace if necessary » page 192, Fuses in the engine compartment.

Do not continue driving if the warning light   does not go off even though the

coolant level is correct and the fuse for the fan is in working order!

Seek help from a specialist garage.

WARNING

■

If you have to stop for technical reasons, then park the vehicle at a safe dis-

tance from the traffic, switch off the engine and activate the hazard warning

light system » page 41.

■

Carefully open the coolant expansion bottle. If the engine is hot, the cooling

system is pressurized – risk of scalding! It is therefore best to allow the engine

to cool down before removing the cap.

■

Do not touch the radiator fan. The radiator fan may switch itself on auto-

matically even if the ignition is off.





Power steering

First read and observe the introductory information and safety warn-

ings on page 12.

If the indicator light



lights up, there is a fault in the power steering system.

The power steering operates with reduced steering assist or does not function at

all.

Seek help from a specialist garage.







 Electronic Stability Control (ESC)

First read and observe the introductory information and safety warn-

ings on page 12.

The warning light flashes to show that the ESC is currently operating.

If the warning light  comes on immediately after you start the engine, the ESC

might be switched off due to technical reasons. Switch the ignition off and on

again. If the indicator light  does not light up after you switch the engine back

on, the ESR is fully functional again.

If the warning light lights up there is a fault in the ESC system.

The following message is shown in the MAXI DOT display.

Error: Electronic Stability Control (ESC)

Error: Traction control (ASR)

Seek help from a specialist garage.

Further information » page 107, Electronic Stability Control (ESC).

Note

If the vehicle's battery has been disconnected and reconnected, the warning light

 comes on after switching on the ignition. The warning light should go out after

driving a short distance.





Traction Control System (ASR)

First read and observe the introductory information and safety warn-

ings on page 12.

The warning light flashes



to show that the ASR is currently operating.

If the warning light



comes on immediately after starting the engine, the ASR

can be switched off for technical reasons. Switch the ignition off and on again. If

the warning light



does not light up after you switch the engine back on, the

ASR is fully functional again.

If the warning light



lights up, there is a fault in the ASR.









Instruments and Indicator Lights

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Rapid - 2013 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Rapid - 2013

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info