Bedienungsanleitung Skoda Rapid Spaceback - 2014 (Seite 166 von 204) (Englisch)

678340

166

Zoom out

Zoom in

Vorherige Seite

1/204

Nächste Seite

›

Grasp the end of the wrench and turn the bolt about one turn in the direction

of the arrow » Fig. 141.

Tightening

›

Push the wheel wrench onto the wheel bolt to the stop

›

Grasp the end of the wrench and turn the bolt against the direction of the

arrow » Fig. 141until it is tight.

After tightening the wheel bolts, the covering caps must be replaced.

WARNING

If it proves difficult to undo the bolts, carefully apply pressure to the end of

the wrench with your foot. Keep hold of the vehicle when doing so, and

make sure you keep your footing.

Raising the vehicle

Fig. 142

Jacking points for positioning

lifting jack

Fig. 143 Attach lifting jack

In order to raise the vehicle, the jack from the tool kit is to be used.

Position the car jack at the jacking point closest to the flat tyre .

The mounting points are located on the metal bar of the lower sill on the un-

derside of your vehicle. The positions of these are embossed by means of

markings on the side surface of the lower sill » Fig. 142.

›

Support the base plate of the jack with its full area resting on level ground

and ensure that the jack is located in a vertical position at the jacking

point » Fig. 143 -



›

Position the lifting jack below the jacking point with the crank and move it up

until its claw encloses the web » Fig. 143 -



›

Continue turning up the jack until the wheel is just about lifted off the

ground.

WARNING

Notes for vehicle lifting

■

Choose a flat and firm surface for jacking the vehicle.

■

If the wheel has to be changed on a slope, first of all block the opposite

wheel with a stone or similar object to prevent the vehicle from unexpect-

edly rolling away.

■

Secure the base plate of the lifting jack with suitable means to prevent

possible moving. A soft and slippery ground under the base plate may move

the lifting jack, causing the vehicle to fall down. It is therefore always nec-

essary to place the lifting jack on a solid surface or use a wide and stable

base. Use a non-slip base (e.g. a rubber foot mat) if the surface is smooth,

such as cobbled stones, tiled floor, etc.

■

Only attach the lifting jack to the attachment points provided for this pur-

pose.

■

Always raise the vehicle with the doors closed.

■

Never position any body parts, such as arms or legs under the vehicle,

while the vehicle is raised with a lifting jack.

■

When the vehicle is raised, never start the engine.

CAUTION

It is important to ensure that the jack is correctly attached to the web of the

lower fork leg, otherwise there is a risk of damage to the vehicle occurring.

Use the appropriate adapter for undoing and tightening the anti-theft wheel bolts » page 164.

163

Emergency equipment and self-help

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Rapid Spaceback - 2014 Seite 166

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Rapid Spaceback - 2014

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info