Bedienungsanleitung Skoda Rapid Spaceback - 2014 (Seite 170 von 204) (Englisch)

678340

170

Zoom out

Zoom in

Vorherige Seite

1/204

Nächste Seite

The battery of another vehicle can be used to jump-start your vehicle if the en-

gine will not start because the battery is flat.

WARNING

■

Pay attention to the warning instructions relating to working in the en-

gine compartment » page 141.

■

A discharged vehicle battery may already freeze at temperatures just be-

low 0 °C. If the battery is frozen, do not jump start with the battery of an-

other vehicle – there is a risk of explosion!

■

Keep any sources of ignition (naked flame, smouldering cigarettes, etc.)

away from the battery – risk of explosion!

■

Never jump-start vehicle batteries with insufficient acid levels – risk of

explosion and chemical burns.

■

The vent screws of the battery cells must be tightened firmly.

Note

We recommend you buy jump-start cables from a car battery specialist.

Jump-starting using the battery from another vehicle

Fig. 146

Jump-starting: A – flat battery, B

– battery providing current

Fig. 147 Engine earth: START-STOP system

Read and observe on page 167 first.

The starting process using the battery of another vehicle requires the use of

jumper cables.

The jump-start cables must be attached in the following sequence.

›

Attach clamp

to the positive terminal of the discharged battery

» Fig. 146.

›

Attach clamp

to the positive terminal of the battery supplying power

›

Attach clamp

to the negative terminal of the battery supplying power

›

Attach the clamp

to a solid metal component firmly connected to the en-

gine block or to the engine block itself.

Starting engine

›

Start the engine on the vehicle providing the power and allow it to idle.

›

Start the engine of the vehicle with the discharged battery.

›

If the engine does not start, halt the attempt to start the engine after 10 sec-

onds and wait for thirty seconds before repeating the process.

›

Remove the jumper cables exactly in the reverse sequence as for clamping.

On vehicles with the START-STOP system, the jump-start cable of the charger

must never be connected directly to the negative pole of the vehicle battery,

but only to the engine earth.

›

1.2 l/63 kW TSI and 1.2 l/77 kW TSI engines » Fig. 147 -



›

1.4 l./90 kW engine » Fig. 147 -



›

1.6 l./77 kW TDI CR engine » Fig. 147 -



Both batteries must have a rated voltage of 12 V. The capacity (Ah) of the bat-

tery supplying the power must not be significantly less than the capacity of

the discharged battery in your vehicle.

Jump-start cables

Only use jump-start cables which have an adequately large cross-section and

insulated terminal clamps. Observe the instructions of the jumper lead manu-

facturer.

Positive cable – colour coding in the majority of cases is red.

Negative cable – colour coding in the majority of cases is black.





167

Emergency equipment and self-help

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Rapid Spaceback - 2014 Seite 170

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Rapid Spaceback - 2014

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info