Bedienungsanleitung Skoda Rapid Spaceback - 2018 (Seite 189 von 256) (Englisch)

678237

189

Zoom out

Zoom in

Vorherige Seite

1/256

Nächste Seite

›

Remove the tow bar from the mounting recess downwards and in the direc-

tion of the arrow

. At the same time, the ball rod latches into the ready po-

sition and is therefore ready to be re-fitted.

After removing the ball rod, insert the cap for the receiving shaft

against

the direction of arrow

» Fig. 221 on page 185.

If the hand wheel

is not turned all the way to the stop, then it will return to

its initial position when the tow bar is removed and will rest on the tow bar and

not engage into the ready position. The ball head then needs to be brought in-

to this position before the next time it is fitted » page 184, Adjusting the ready

position.

The ball rod must be cleaned before storing in the box with the vehicle tool al-

ways.

WARNING

Never allow the tow bar to remain unsecured in the boot. This could cause

damage to the boot upon sudden braking, and could put the safety of the

occupants at risk.

Vertical load with mounted accessories



Read and observe on page 183 first.

When using the accessories (e.g. bicycle carrier), the maximum length and the

permissible total weight including load must be considered.

The maximum length of the mounted accessories (from the ball of the towing

device) may not exceed 70 cm.

The permissible total weight of the installed accessory, including its load, cor-

responds to the maximum trailer load on trailers, but must not exceed 50 kg.

This value applies if the center of gravity is at a distance of no more than 30

cm from the towing device ball head.

If the distance of the centre gravity of the load to the ball head of the tow-

ing device is greater than 30 cm, then the max. permissible total weight of

the accessory, including its load, decreases (e.g. at a distance of 60 cm

from the ball head, the permissible weight decreases by half).

CAUTION

Never exceed the permissible total weight of the accessories incl. load and

maximum length of the accessories – There is a risk of damage to the towing

device.

Note

We recommend that you use accessories from ŠKODA Original Accessories.

Using the towing device

Trailer (accessory) connect and disconnect

Fig. 227

Swivel out the 13-pin power

socket, safety eyelet

Connecting / disconnecting

›

Install the tow bar and the remove the protective cap

» Fig. 217 on

page 184.

›

Place the trailer (the accessory) onto the ball head.

›

Grasp the 13-pin socket at the handle

and swing out in the direction of

the arrow » Fig. 227.

›

Plug the trailer (accessory) connector into the 13-pin socket. (If the trailer /

accessories have a 7-pin connector, use a corresponding adapter from the

ŠKODA Original Accessories).

›

Suspend the breakaway cable of the trailer at the safety eyelet

(the

breakaway cable must sag in all trailer settings in view of the vehicle).

Uncoupling takes place in reverse order.

Exterior mirrors

You should have additional exterior mirrors fitted if you are not able to see the

traffic behind the trailer using the standard rear-view mirrors.



187

Towing device and trailer

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Rapid Spaceback - 2018 Seite 189

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Rapid Spaceback - 2018

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info