Bedienungsanleitung Skoda Rapid Spaceback - 2018 (Seite 204 von 256) (Englisch)

678237

204

Zoom out

Zoom in

Vorherige Seite

1/256

Nächste Seite

›

Always top up using coolant of the correct specification.

›

Turn the cap until it clicks into place.

The specification for the coolant is shown in the coolant expansion reservoir

» Fig. 235.

If the specified coolant is not available, then refilling only with distilled or dem-

ineralised water, and get a specialist garage to correct the water-coolant addi-

tive mix as soon as possible.

CAUTION

■

If the expansion tank is empty, do not top up with coolant. The system could

aerate - risk of engine damage!  Do not drive the vehicle! Switch off the en-

gine and seek assistance from a specialist garage.

■

Do not fill the coolant above the mark

» Fig. 235. The coolant could, when

heated, be expelled from the cooling system - risk of damage to the engine

parts.

■

If it is not possible to add coolant,  do not continue driving! Switch off the

engine and seek assistance from a specialist garage.

■

A coolant additive which does not correspond to the correct specification

can reduce the anti-corrosion effect of the cooling system - risk of damage to

the cooling system and the engine.

■

If non-distilled (non-demineralised) water has been used to top up, the cool-

ant should be replaced by a specialist garage - risk of engine damage.

■

A loss of coolant indicates leaks in the cooling system - risk of engine dam-

age. Top up with coolant and then seek assistance from a specialist garage.

Note

A coolant level which is too low is indicated in the instrument cluster by the

warning light  and a corresponding message » page 43. We still recommend

inspecting the coolant level directly at the reservoir from time to time.

Brake fluid

Fig. 236

Brake fluid reservoir

Check the brake fluid under the following conditions.

The vehicle is on a horizontal surface.

The engine is turned off.

Checking the brake fluid level – The brake fluid level must lie between the

markings “MIN” and “MAX”» Fig. 236.

Specification - the brake fluid must comply with the standard VW 501 14 (this

standard meets the requirements of FMVSS 116 DOT4).

The brake fluid change is carried out during the inspection.

WARNING

■

If the date of the brake fluid change is exceeded, steam bubbles could

form in the brake system during heavy braking. This can impair the efficien-

cy of the brakes – risk of accident!

■

The following instructions must be followed at all times when working on

the engine compartment » page 198.

■

If the fluid level drops significantly within a short time or if it drops below

the “MIN” » Fig. 236 mark, this may be an indication of a leak in the brake

system.  Do not continue driving - There is a risk of accident! Seek help

from a specialist garage.

Note

A brake fluid level which is too low is indicated in the instrument cluster by the

warning light  and a corresponding message» page 38. We still recommend

inspecting the brake fluid level in the reservoir from time to time.



202

General Maintenance

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Rapid Spaceback - 2018 Seite 204

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Rapid Spaceback - 2018

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info