Bedienungsanleitung Skoda Superb - 2009 (Seite 200 von 294) (Englisch)

678360

200

Zoom out

Zoom in

Vorherige Seite

1/294

Nächste Seite

Intelligent Technology 199

Using the system Safety Driving Tips General Maintenance Breakdown assistance Technical Data

Tyre inflation pressure-control system*

The tyre inflation pressure-control system compares with the aid of the ABS sensors

the speed and also the rolling circumference of the individual wheels. If the rolling

circumference of a wheel is changed, the warning light° lights up in the instru-

ment cluster ⇒ page 39. The rolling circumference of the tyre can change if:

• the tyre inflation pressure is too low,

• the structure of the tyre is damaged,

• the vehicle is loaded on one side,

• the wheels of an axle are loaded heavily (e.g. when towing a trailer or when

driving uphill or downhill),

• snow chains are mounted,

• the temporary spare wheel is mounted,

• one wheel per axle was changed.

Basic setting of tyre inflation pressure-control system

After changing the tyre inflation pressures or after changing one or several wheels,

a basic setting of the system must be carried out as follows.

• Inflate all tyres to the specified inflation pressure ⇒ page 235.

• Switch on the ignition.

• Press button ⇒ fig. 192 for more than 2 seconds. While pressing the

button, the warning light  lights up. At the same time the memory of the system

is erased and the new calibration is started, which is confirmed with an audible

signal and then the warning light  goes out.

• If the warning light  does not go out after the basic setting, there is a fault in

the system. Have the vehicle inspected by your nearest specialist garage.

Warning light  lights up

If the tyre inflation pressure of at least one wheel is insufficiently inflated in compar-

ison to the stored basic value, the warning light  ⇒ lights up.

Warning light  flashes

If the warning light flashes, there is a system fault. Have the vehicle inspected by

your nearest specialist garage.

WARNING

• When the warning light  lights up, immediately reduce the speed and

avoid sudden steering and brake manoeuvres. Please stop the vehicle

without delay at the nearest possible stop and inspect the tyres and their

inflation pressures.

• The driver is responsible for the correct tyre inflation pressures. For this

reason, the tyre inflation pressures must be checked regularly.

• Under certain circumstances (e.g. sporty style of driving, wintry or

unpaved roads) the warning light  can be delayed or does not light up at

all.

• The tyre inflation pressure-control system does not take away the

responsability from the driver for the correct tyre inflation pressure.

Note

The tyre inflation pressure-control system:

• does not replace the regular tyre inflation pressure control, because the system

cannot detect an even pressure loss,

• cannot warn in case of very rapid tyre inflation pressure loss, e.g. in case of

sudden tyre damage. In this case carefully bring the vehicle to a standstill without

sudden steering movements and without sharp braking.

Fig. 192 Button for setting

the tyre inflation pressure

control value

 

s2dk.1.book Page 199 Wednesday, April 8, 2009 12:23 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Superb - 2009 Seite 200

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Superb - 2009

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info