Bedienungsanleitung Skoda Superb - 2014 (Seite 214 von 252) (Englisch)

678350

214

Zoom out

Zoom in

Vorherige Seite

1/252

Nächste Seite

WARNING

■

If you cannot inflate the tyre to at least 2.0 bar, this means the damage

sustained was too serious. The sealing agent cannot be used to seal the

tyre.



Do not continue to drive! Seek help from a specialist garage.

■

The tyre inflation hose and air compressor may get hot as the tyre is be-

ing inflated – there is a risk of burning.

CAUTION

Switch off the air compressor after running 8 minutes at the latest – there is a

risk of overheating. Allow the air compressor to cool a few minutes before

switching it on again.

Notes for driving with tyre repaired

Read and observe on page 209 first.

The inflation pressure of the repaired tyre must be checked after driving for 10

minutes.

If the tyre pressure is 1.3 bar or less

›



Do not continue to drive! You cannot properly seal with tyre with the

breakdown kit.

If the tyre pressure is 1.3 bar or more

›

Set the tyre pressure back to the correct value.

›

Continue driving carefully to the nearest specialist garage at a maximum

speed of 80 km/h (50 mph).

Jump-starting



Introduction

This chapter contains information on the following subjects:

Jump-starting using the battery from another vehicle 211

Jump-starting in vehicles with the START STOP system

212

Jump-starting vehicles with the vehicle battery in the boot

212

The battery of another vehicle can be used to jump-start your vehicle if the en-

gine will not start because the battery is flat.



WARNING

■

Pay attention to the warning instructions relating to work in the engine

compartment » page 186.

■

A discharged vehicle battery may already freeze at temperatures just be-

low 0 °C. If the battery is frozen, do not jump-start with the battery of an-

other vehicle – there is a risk of explosion.

■

Keep any sources of ignition (naked flame, smouldering cigarettes, etc.)

away from the battery – risk of explosion!

■

Never jump-start vehicle batteries with insufficient acid levels – risk of

explosion and chemical burns.

■

The vent screws of the battery cells must be tightened firmly.

Note

We recommend you buy jump-start cables from a car battery specialist.

Jump-starting using the battery from another vehicle

Fig. 184

Jump-starting: A – flat battery, B

– battery providing current

Read and observe on page 211 first.

The starting process using the battery of another vehicle requires the use of

jumper cables.

The jump-start cables must be attached in the following sequence.

›

Attach clamp

to the positive terminal of the discharged battery

» Fig. 184.

›

Attach clamp

to the positive terminal of the battery supplying power

›

Attach clamp

to the negative terminal of the battery supplying power

›

Attach clamp

to a solid metal component firmly connected to the engine

block or to the engine block itself.

Starting engine

›

Start the engine on the vehicle providing the power and allow it to idle.





211

Emergency equipment and self-help

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Skoda Superb - 2014 Seite 214

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Skoda Superb - 2014

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info