590662
17
Zoom out
Zoom in
Vorherige Seite
1/26
Nächste Seite
17
- Enter 1234 (or your personal code), followed by .
4.3 Chime mode
You can set the station into chime mode. In this mode, it will emit a "ding-dong" when you pass in front of a
movement detector or when you open a door/window equipped with a magnetic detector.
CAUTION: In this mode the self-protections and the detectors saved in panic area will always be active and will
trigger the station.
To set the station into chime mode:
- Enter 1234 (or your personal code), followed by 3.
4.4 Test mode
The station can be set in test mode in order to test the system or to operate on an accessory (e.g.: change a battery)
without to trigger the system (station, siren and/or transmitter).
To set the station into test mode:
- Enter 1234 (or your personal code), followed by 03, the STATUS LED will light up once and a beep will be
emitted to confirm that the station is in test mode.
Accessory test
When the station is in test mode, actuate every system detector by walking in a protected area or by opening a
protected door/window. Every time a detector is activated, the station emits a beep to indicate that a signal has been
received.
You can also test the self-protection of every detector by opening its casing. At each activation of a self-protection,
the station emits a beep.
To test the remote control, just push each of its keys. Each time these keys are pressed, the station emits a beep.
Phone transmitter test
You can test the station phone transmitter to check that, for example, there is no connecting error.
To test the transmitter, push the key 9 for 3 seconds. Then the station will call the first number saved in its memory.
If you want to test all numbers, you have to simulate a real triggering and let the station ring without to stop it. To do
this test, you can set the station in silent mode (see page 11).
To exit the station from test mode:
- Push the key *, the STATUS LED will light up once and a beep will be emitted to confirm that the station have
left test mode.
NOTE: The station will exit test mode automatically after 10 minutes.
17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Smartwares HA700 plus wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Smartwares HA700 plus

Smartwares HA700 plus Bedienungsanleitung - Holländisch - 26 seiten

Smartwares HA700 plus Bedienungsanleitung - Holländisch, Französisch - 52 seiten

Smartwares HA700 plus Zusatzinformation - Alle Sprachen - 4 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info