3. Empty the drip tray and grounds container
(A4) and wash them;
4. Remove the drip tray complete with grounds
container (A4).
5. Close the service door.
Cleaning the water tank
1. Clean the water tank (A12) regularly (about
once a month) with a damp cloth and a little
mild washing up liquid.
2. Clean to remove all washing up liquid resi-
dues, then rinse the water tank thoroughly.
Cleaning the spouts
1. Clean the spouts (A13) periodically using a
sponge or cloth (fig. 25).
2. Check regularly that the holes in the coffee
spout are not blocked.
If necessary, remove coffee deposits with a
toothpick (fig. 23).
Cleaning the pre-ground coffee funnel
• Check regularly (about once a month ) that
the pre-ground coffee funnel (A21) is not
blocked.
If necessary, remove coffee deposits with a
knife (fig. 17).
Danger!
Before performing any cleaning
operations, the machine must be turned off by
pressing the main switch (A23) and unplugged
from the mains power supply.
Never immerse the coffee maker in water.
Cleaning the inside of the coffee
maker
1. Check regularly (about once a week) that the
inside of the appliance is not dirty.
If necessary, remove coffee deposits with a
knife and a sponge.
2. Remove the residues with a vacuum cleaner
(fig. 26).
Cleaning the infuser
The infuser (A5) must be cleaned at least once a
month.
Important!
The infuser (A5) must not be
removed when the appliance is on. Do not at-
tempt to use force to remove the infuser as this
could damage the coffee maker.
1. Make sure the machine is correctly turned off
(see "Turning the appliance off").
2. Open the service door (A2) (fig. 13).
3. Remove the drip tray (A14) and the grounds
container (fig. 14);
4. Press the two red release buttons inwards
and at the same time pull the infuser out-
wards (fig. 27).
Important!
Do not use washing up liquid
to clean the infuser. It would remove the lubri-
cant applied to the inside of the piston, causing
the infuser to seize up and become unusable. Do
not put in the dishwasher.
5. Soak the infuser in water for about 5 minu-
tes, then rinse under the tap.
6. After cleaning, replace the infuser (A5) by sli-
ding it onto the internal support and pin at
the bottom,
then push the PUSH symbol fully in until it
clicks into place.
N.B.!
If the infuser is difficult to insert,
you must first adapt it to the right dimension by
pressing it forcefully from the bottom and top as
shown in the figure.
Pin
Support
18
