Bedienungsanleitung Smeg CMS4604NR (Seite 18 von 32) (Englisch)

682757

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

Cleaning the pre-ground coee funnel

Check regularly (about once a month ) that the pre-ground

coee funnel (A21) is not blocked. If necessary, remove coee

deposits with the brush (C5) supplied.

Cleaning the infuser

The infuser must be cleaned at least once a month.

Important! The infuser (A5) must not be removed

when the appliance is on. Do not use force to remove the infuser.

1. Make sure the machine is correctly turned o (see "Turning

o").

2. Open the service door.

3. Remove the drip tray and waste coee container (g.27).

4. Press the two coloured release buttons inwards and at the

same time pull the infuser outwards (g.32).

Important! Do not use washing up liquid to clean the

infuser to avoid removing the lubricant applied to the inside of

the piston.

5. Soak the infuser in water for about 5 minutes, then rinse.

6. After cleaning, replace the infuser (A5) by sliding it onto the

internal support and pin at the bottom, then push the PUSH

symbol fully in until it clicks into place (g.33).

Please note carefully: If you encounter diculty in-

serting the infuser, (before inserting it) you must adapt it to the

right dimension by pressing it forcefully from the bottom and

top as shown in the gure 34.

7. Once inserted, make sure the two coloured release buttons

have snapped out (g.35).

8. Replace the drip tray and waste coee container.

9. Close the service door.

Cleaning the milk container (D)

Clean the milk container after each time you prepare milk, as

described below:

1. Lift and remove the lid (D2);

2. Extract the milk container (D3) from the thermal casing

(D6), holding it by the two side grips.

Important!

The thermal casing must not be lled or immersed in wa-

ter: to clean it wipe with a damp cloth.

3. Remove the milk spout (D5) and intake tube (D4).

4. Turn the froth adjustment dial clockwise to the "INSERT"

position (g.36) and pull o.

5. Wash all the components of the frother thoroughly with

hot water and mild washing-up liquid. All components and

the container are dishwasher safe, placing them in the top

basket of the dishwasher.

Pay particular attention to check in the hollow and groove

under the dial (

g.37

) that no milk residues remain: scrape

any residue from the groove with a toothpick.

6. Rinse inside the froth adjustment dial seat (g.38) and the

milk frother connector hole using running water.

7. Check as well that the intake tube and spout are not

clogged with milk residues.

8. Replace the dial, lining up the arrow with the word INSERT,

the spout and milk intake tube.

9. Place the milk container in the thermal casing.

10. Place the lid back on the milk container.

Cleaning the hot water/steam connection nozzle

Each time you prepare milk, clean the connection nozzle (A13)

with a sponge to remove milk residues deposited on the seals

(g.23).

DESCALING

Important!

• Before use, read the instructions and the labelling on the

de-scaler packaging.

• You should use de-scaler authorised by the manufactur-

er only. Using unsuitable de-scaler and/or performing

de-scaling incorrectly may result in faults not covered by

the manufacturer's guarantee.

De-scale the appliance when the display (B) shows message

DESCALING NEEDED PRESS OK TO START (~45min) : to

de-scale immediately, press

and follow the instructions

from point 4.

To postpone de-scaling to another time, press : on the

display the symbol is a reminder that the appliance needs

to be de-scaled (the message will be re-proposed every time the

machine is switched on).

To access the de-scaling menu:

1. Press (B2) to enter the menu;

2. Press (B10) or (B8) until the display shows

DESCALE;

3. Press to start the de-scaling cycle then follow the in-

structions on the display;

4. REMOVE WATER FILTER (g. 39):extract the water tank

(A12), remove the water softener lter (C4) (if present) and

empty the water tank. Press ;

5. ADD DESCALER (UP TO LEVEL A) AND WATER (UP TO LEVEL

B) (g.40); Pour the de-scaler into the tank up to the level

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Smeg CMS4604NR Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Smeg CMS4604NR

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info