Bedienungsanleitung Smeg CR 330 A (Seite 18 von 61) (Deutsch, Englisch, Holländisch, Französisch, Italienisch)

69851

Zoom out

Zoom in

Vorherige Seite

1/61

Nächste Seite

Tips on Saving Energy

Keeping Your Appliance in Shape

Before doing any cleaning, disconnect the appliance

from the electricity (by pulling out the plug or turning

off the general switch in your home).

Defrosting

WARNING: do not damage the refrigeration circuit.

Do not use mechanical devices or other tools to speed

up the defrosting process, unless they have been rec-

ommended by the manufacturer.

How to Defrost the Refrigerator

This appliance defrosts automatically and the water is

channeled to the back toward the drain installed for this

purpose (fig. 2). Here, the heat produced by the compressor

will make it evaporate. The only thing you must do is to

periodically check and clean the hole of the drain, which is

located behind the vegetable crispers, so that the water

drains properly.

How to Defrost the Freezer

- Every so often, remove the frost with the scraper provided

with the appliance (do not use knives or metal objects).

- If the frost is more than 15 mm thick, the freezer must be

defrosted.

Proceed as follows: turn the thermostat knob (G ) to the ·

setting "0" (Fig. 3). Then wrap all the frozen and fast-frozen

food in newspaper, placing it either in the refrigerator or in

a cool place. Leave the freezer door open so that the frost

thaws completely. You can speed this process by placing con-

tainers of warm water in the compartment.

The unit is provided with a system which allows the defrost

water to be collected in a container to be placed beneath

the unit (proceed as illustrated in fig. 4).

Fig. 3

Fig. 4

Fig. 2

- Install the Appliance Properly

In other words, away from sources of heat and direct sun-

light, in a well ventilated room complying with the mini-

mum distances indicated in the paragraph entitled, “ Instal-

lation/Ventilation.”.

THE ACTUAL ENERGY CONSUMPTION OF THE

APPLIANCE DEPENDS ON THE WAY THE SAME IS USED

AND ON ITS LOCATION.

The consumption tests were performed in 560mm deep

column units, the most common installation setting for this

appliance.

- Use the Right Temperature Setting

A setting which is too cold increases energy consumption.

- Do not Overfill

To conserve food properly, the cold air must circulate freely

within the refrigerator. If it is overfilled, this will prevent proper

air circulation, forcing the compressor to work continuously.

- Close the Doors

Open your refrigerator as little as possible because each time

you do so you loose much of the cold air. To raise the tem-

perature to the proper level again, the motor must work for

a long time, consuming energy.

- Keep an Eye on the Seals

Keep the seals clean and make sure that they adhere well to

the door. This alone will ensure that no cold air escapes.

- No Hot Foods

A hot pot or pan placed in the refrigerator immediately raises

the temperature several degrees. Let hot cookware and food

cool to ambient temperature before placing them in the re-

frigerator.

- Defrost the Freezer

Check the thickness of the frost on the walls of the freezer

and immediately defrost it if the layer of frost is too thick.

(see the section entitled, “Keeping your Appliance in Shape”).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Smeg CR 330 A Seite 18

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info