Bedienungsanleitung Smeg cr328apzd (Seite 12 von 15) (Englisch)

346907

Zoom out

Zoom in

Vorherige Seite

1/15

Nächste Seite

1. The appliance does not work and the displays are off.

•

Is there a power failure?

•

Is the plug properly inserted in the socket?

•

Is the double-pole switch on?

•

Has the fuse blown?

•

Is the power cord damaged?

2. Temperature inside the compartments is not low enough.

•

Are the doors closed properly?

•

Is the appliance installed near a heat source?

•

Is the temperature correctly set?

•

Is the air circulation through the ventilation grilles at the bottom of the appliance obstructed?

3. Water collects at the bottom of the refrigerator compartment.

•

Is the defrost water drain blocked?

(see “Appliance periodical maintenance and cleaning”)

4. The inside light is not working.

- Perform the checks for problem 1, and then:

•

Disconnect the appliance from the mains power supply. To inspect the bulb, refer to the instructions

and illustration on the attached product description sheet.

•

Check the bulb and, if necessary, replace it with a new one of (max. 25 W available only from the

Assistance Service).

5. The red light on the control panel remains on and/or the acoustic alarm is activated.

The warning light and the alarm are activated for the following reasons:

1. Temperature alarm (red light on and acoustic signal activated)

•

Large amounts of fresh food have been recently placed inside the freezer

•

The freezer door does not close perfectly (see chapter “How to operate the freezer compartment”)

2. “Power failure” alarm (red light on, acoustic signal activated and freezer display flashing)

•

The appliance has undergone a power failure (see chapter “How to operate the freezer compartment”)

3. ”Faulty freezer sensor” alarm (red light on, acoustic signal activated and the letter C is present on

the freezer display)

•

The freezer compartment temperature sensor is faulty, however the appliance continues to work

with an emergency procedure. Call assistance.

4. “Faulty refrigerator sensor” alarm (red light on, acoustic signal activated and the letter C or E is

present on the refrigerator display)

•

A refrigerator compartment temperature sensor is faulty, however the appliance continues to work

with an emergency procedure. Call assistance

Notes:

• The front edge of the appliance may be hot. This prevents the formation of condensation and

is not a defect.

• If the temperature cannot be adjusted, check if the control panel lock is deactivated.

AFTER SALES SERVICE

Before contacting After Sales Service:

See if you can solve the problem yourself (see

Troubleshooting guide).

Switch the appliance on again to see if the

problem has been solved. If it has not,

disconnect the appliance from the power

supply and wait for about an hour before

switching on again.

If the problem persists after this course of

action, contact After-sales Service.

-Specify:

•

the nature of the fault;

•

the model;

•

the Service number (the number after the

word SERVICE on the rating plate on the rear

of the appliance);

•

your full address;

•

your telephone number and area code.

Note:

The direction of door opening can be changed.

If this operation is performed by After-sales

Service it is not covered by the warranty.

60802020aGB.fm Page 27 Wednesday, July 26, 2006 5:21 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Smeg cr328apzd Seite 12

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Smeg cr328apzd

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info